Refrigeration and Air Conditioning Equipment Cooling Episode 2 docx

... transfer at the interface and this simplifies predictions of the performance of air-conditioning coils [1, 5, 9]. Refrigeration and Air-Conditioning Preface Refrigeration and its application is ... of suction gas 3. Non-corrosive, non-toxic and non-flammable 4. Critical temperature and triple point outside the working range 38 Refrigeration and Air-Conditioning throw...

Ngày tải lên: 05/03/2014, 19:20

... estimating emissions from the manufacturing of refrigera- tion and air conditioning equipment is found in the Climate Leaders guidance for Direct HFC and PFC Emissions From Manufacturing Refrigeration ... Of ce of Air and Radiation Refrigeration/ AC Equipment Use — Guidance SECTION 2 Methods for Calculating Emissions M ost large companies will h...

Ngày tải lên: 08/03/2014, 19:20

... Department of Mechanical Technology Refrigeration and Air Conditioning - 78 - Refrigeration and Air Conditioning Major Mechanical Technology Department ELT 131 Code Refrigeration ... References: Department of Mechanical Technology Refrigeration and Air Conditioning - 21 - Refrigeration and Air Conditioning...

Ngày tải lên: 01/04/2014, 00:20

... instruction in refrigeration and air conditioning. The scope of this subcourse takes in unit components of the absorption system, including their functions and maintenance; water treatment methods and their ... Check the standpipe for water seal circulation before starting the pumps. (8) Start the chilled water pump and open the valves to insure circulation through the evaporato...

Ngày tải lên: 27/06/2014, 05:20

... liquid state. Since the latent heat and density of fluids are much greater than the sensible heat and density of the vapour, the rates of heat transfer are considerably higher. The process can be ... temperature of the first layer of the solid, and the remaining heat passes on to the next layer, and so on. Calculations for heating or cooling times...

Ngày tải lên: 27/06/2014, 17:20

... choice of refrigerant is therefore about the efficiency of the refrigerant and the efficiency of the refrigeration system. The less the amount of energy needed to produce each kW of cooling, the ... liquid state. Since the latent heat and density of fluids are much greater than the sensible heat and density of the vapour, the rates of heat t...

Ngày tải lên: 27/06/2014, 18:20

... contributes CO 2 emission to the atmosphere. The choice of refrigerant is therefore about the efficiency of the refrigerant and the efficiency of the refrigeration system. The less the amount of energy ... copper. This chapter is about the new refrigerants and the new attitude needed in design, maintenance and servicing of refrigeration equipment. 3. 2 Ideal properties for a re...

Ngày tải lên: 12/08/2014, 00:20

... of refrigerant. 6 REFRIGERATION AND AIR CONDITIONING IV (EQUIPMENT COOLING) Subcourse OD1750 Edition A United States Army Combined Arms Support Command Fort Lee, VA 238 01- 1809 14 Credit Hours INTRODUCTION This ... of a D/X coil solenoid valve and modulating control of a return air bypass damper. 3 SUBCOURSE EDITION OD1750 A REFRIGERATION AND AIR CONDITIONING IV...

Ngày tải lên: 12/08/2014, 16:21

... 5) 21 . During gauge installation, in which position is the shutoff valve set and why? (Sec. 3, Par. 9) 22 . Where would you install a liquid line sight glass in the system? (Sec. 3, Par. 12) 23 . ... R- 12, R-13, and R -22 . As the water vaporizes, the water vapor travels from the evaporator to the absorber, where it is absorbed into the salt solution. The evaporator pump, shown in it...

Ngày tải lên: 12/08/2014, 16:21

... Resume normal operation by filling 31 TABLE 11 TABLE 12 TABLE 13 41 Figure 33 . Pressure and temperature curve. Figure 34 . Seal water system. 36 (6) Purge cooling coil (keeps purge solution ... closed cycle to the cooling coils. This refrigeration effect is known as flash cooling. 5. In reference to item 3 of figure 28, note the addition of the generator and accessory...

Ngày tải lên: 12/08/2014, 16:21

... scale, the refrigeration man knows that corrosion is a constant problem. Let us now study corrosion, its causes, its effects, and its control. 22. Corrosion 1. In the refrigeration/ air- conditioning ... (Sec. 16, Par. 3) 43. Where is the weir and trap located on the purge unit? (Sec. 16, Par. 3) 44. High head pressure indicates that ___________________. (Sec. 16, Par. 5) 45. How i...

Ngày tải lên: 12/08/2014, 16:21

... ___________________. (Sec. 28, Par. 2) 18. When is it necessary to pipe water from a clean water source to the stuffing box? (Sec. 28, Par. 3) 19. Why is exact packing tightening important? (Sec. 28, Par. 4) 20. ... Figure 88 . Electron flow in a diode. term “diode” refers to the number of elements within the tube envelope (di meaning two) rather than to any specific application, as shown...

Ngày tải lên: 12/08/2014, 16:21

... following systems are typical examples of how electronics is applied to the control of air- conditioning and equipment cooling systems. The control sequence is given for each application. 6. Refrigerant ... matter or air bubbles; the best control for this type of corrosion is a good filtration system, and air purging valves installed in the highest point of the water system. (...

Ngày tải lên: 12/08/2014, 16:21

... cooler Throttle valve Solenoid valve 92 Refrigeration and Air- Conditioning Where the surrounding air is always at + 4 C or higher, it will be sufficient to stop the refrigerant for a period and allow the frost to melt ... sleeve and is used to detect the position of the 110 Refrigeration and Air- Conditioning 9.7 Solenoid valves Electrically operated shut-off valves (F...

Ngày tải lên: 13/08/2014, 17:20