Root Cause Failure Analysis Part 9 pdf

... 2 39 252 Root Cause Failure Analysis Table 21-1 Common Failure Modes of Pneumatic Conveyors I THE CAUSES Piping Configuratkn Unsuitable IPiping Leakage4 240 Root Cause Failure ... axial thrusting caused by the frequent variations in suction or discharge pressure caused by the stadstop operation. 244 Root Cause Failure Analysis Table 19- 2 Common...

Ngày tải lên: 11/08/2014, 21:23

... manifold with posi- 140 Root Cause Failure Analysis Figure 1&11 kaf spring configuration (Gibbs 197 1). the rod. The amount of heat generated can be considerable, particularly when moderate ... cantilever, centerline, and bullgear. 123 134 Root Cause Failure Analysis Figur *e 10-8 Liquidseal ring rotary air compressor (Gibbs 197 1). Liquid-ring comp...

Ngày tải lên: 11/08/2014, 21:23

... Table 23-1 Common Failure Modes of Mixers and Agitators Source: Integrated Systems, Inc. 286 Root Cause Failure Analysis Table 31-1 Common Failure Modes of Wear Part Surfaces Source: ... teeth. 268 Root Cause Failure Analysis Table 24-2 Common Failure Modes of Cyclonic Separators THE I I Source: Integrated Systems, Inc. Control Valves Table...

Ngày tải lên: 11/08/2014, 21:23

... increased difficulty is that the cause often is subjective. ROOT CAUSE FAILURE ANALYSIS Part I INTRODUCTION TO ROOT CAUSE FAILURE ANALYSIS ROOT CAUSE FAILURE ANALYSIS R. Keith Mobley ... that leads to failure. Instead, it displays all the possible causes that CONTENTS Part I Introduction to Root Cause Failure Analysis Chapter 1 Introduction...

Ngày tải lên: 11/08/2014, 21:23

... q-) use not enforced L.C"f?%EF-) Figure 3 -9 Common root causes of procedure-related problems. 46 Root Cause Failure Analysis 4 Polides and Procedures No standards Confusng ... potential root causes to verify each of the suspect causes is essential. In almost all cases, a relatively simple, inexpensive test series can be devel- Root Cause Failure...

Ngày tải lên: 11/08/2014, 21:23

... 74-87-3 624-83 -9 7 697 -37-2 594 -42-3 7616 -94 -6 79- 38 -9 10,000 1,500 1,500 5,000 5,000 1,500 5.000 100 1 ,000 15,000 250 500 150 5,000 10,000 Source: OSHA 191 0.1 19, Appendix ... selected with care. 77 56 Root Cause Failure Analysis Causes and Long-Term Corrective Actions This section of the report should clearly describe the specific root...

Ngày tải lên: 11/08/2014, 21:23

... 148 Root Cause Failure Analysis Figure 11-1 Top-entering propeller-type mixer (Thomas Register 199 5). Figure 11-2 Side-entering propeller-type mixer (Thomas Register 199 5). 168 Root Cause ... prevent stress failure. Smaller- diameter rolls can be reduced in a single step, but they also must have stress relief by undercutting to prevent failure. 144 Root Cause...

Ngày tải lên: 11/08/2014, 21:23

... double-enveloping 90 -98 Not available 97 -99 97 -99 Not available 97 -99 97 -99 97 -99 50 -99 50 -98 Source: Adapted by Integrated Systems, Inc., from “Gears and Gear Drives.” 199 6 Power ... included in the standard operating procedures. 178 Root Cause Failure Analysis Figure 1 49 Basic cone shape of bevel gears (Neale 199 3). Two major differences b...

Ngày tải lên: 11/08/2014, 21:23

... Pneumatic or hydraulic cylinders are used as actuators (Higgins and Mobley 199 5). 226 Root Cause Failure Analysis Figure 18-6 Selecting correct packing size (Bearings Znc. catalogue). ... valve. Because of heat buildup, solenoid actuators must be limited to short-duration activation. A brief burst of electrical energy is transmitted to the sole- 212 Root Cause...

Ngày tải lên: 11/08/2014, 21:23

... Second Edition by Heinz P. Bloch and Claire Soares 199 8 731~~ hc 0-7506-7081 -9 Root Cause Failure Anatysis by R. Keith Mobley 199 9 296 ~~ hc 0-7506-7158-0 Detailed information on these ... Roy E. Sanders 199 9 288~~ hc 0-7506-7022-3 Fluid Power Dynamics by R. Keith Mobley 199 9 360~~ hc 0-7506-7174-2 Maintenance Fundamentals by R. Keith Mobley 199 9 35...

Ngày tải lên: 11/08/2014, 21:23