Safety at Work 6 E Part 7 docx

... hold them liable. At an individual level hazard detection is limited by what is foreseeable or foreseen. However, if people cannot foresee exactly what 368 Safety at Work needed. The latter point ... reinforce or destroy their effect. The tone of voice can indicate boredom, the stance friendliness, hand movements nervousness. The very different effect of messages over the telephone F...

Ngày tải lên: 11/08/2014, 21:21

... and to remove waste matter created during the chemical reaction when the phosphates stored in the muscles degenerate to create energy. 3.9.2.4 Spinal column In the process of evolution, the bony ... a workplace where, at the design stage, little if any thought had been given to ergonomic issues. Even where consideration has been given at the design stage improvements can still be made. Ge...

Ngày tải lên: 11/08/2014, 21:21

... purposes, 76 2 fired and heated vessels, 76 2 pipeline examination, 79 5 6 piping, 76 2 Pressure Equipment Directive, 76 0 record keeping, 76 5 6 regulations for safe use, 76 3 6, 79 4 6 rigid construction examination, 79 5 6 transportable ... 569 time weighted average (TWA) values, 574 units and recommendations, 574 ventilation control, 575 7 ventilation performance assessment...

Ngày tải lên: 11/08/2014, 21:21

... the cause of health and safety of workpeople for so many years. Not least among these are the relationships that have developed between employers and employees that are so essential for good performance ... requirements 77 2 4.4.4 Voltage levels 77 3 4.4.5 Electrical accidents 77 3 4.4 .6 The basic electrical circuit 77 4 4.4 .7 Dangers from electricity 77 5 4.4.8 Protective means 7...

Ngày tải lên: 11/08/2014, 21:21

... mowers – Safety. These standards are prepared by working parties whose members are representatives of the participating Member States – including members of EU, EFTA plus some from Eastern European ... and orders. These regulations have the objective of detailing legislative require- ments in the specific area at which they are aimed although there has been a trend – reflecting the requir...

Ngày tải lên: 11/08/2014, 21:21

... recognised in the workplace the right to appoint safety representatives. Those safety representatives were given certain func- tions and employers were required to give to the representatives, ... the employee performed, or proposed to perform, the functions of a representative or a member of a safety committee, (c) being an employee at a workplace where: (i) there was no such represe...

Ngày tải lên: 11/08/2014, 21:21

... 3: Evaluate the risks and decide whether existing precautions are adequate or more should be done Step 4: Record the findings Step 5: Review the assessment and revise it if necessary. Effective ... etc. The consequences of poor maintenance of these systems are the release into the atmosphere of contaminated aerosol vapours that affect not only the relatively healthy employees but also neighbo...

Ngày tải lên: 11/08/2014, 21:21

... recommendations resulting from the application of system safety analysis techniques can be effectively reviewed and implemented. System safety analyses employ the three basic elements of identifica- tion, ... methodology requires the consideration of two basic and interrelated aspects, namely system safety management and system safety analyses. System safety management provides the...

Ngày tải lên: 11/08/2014, 21:21

... have opted for the quality management system to integrate environment and health and safety into one comprehensive management process. Figure 2 .6. 2 interrelates the elements of these management standards with ... appropriate intervals and adequately documented. This is, in effect, a check on the operation of the risk assessment element of the Safety Management System and, where weakness...

Ngày tải lên: 11/08/2014, 21:21

... department 2. All work procedures will be reviewed every three years Work procedures to be reviewed by the workplace representative 3. Safety committees at appropriate organisational levels will meet bi- monthly ... senior safety committee ORGANISING 1. Each job will have specified safety responsibilities which are reviewed every 3 years Job responsibilities to be reviewed/checked...

Ngày tải lên: 11/08/2014, 21:21