Mechanical Engineer''''''''s Reference Book 2011 Part 8 potx
Mechanical Engineer''''s Reference Book 2011 Part 8 potx
... = + sin20 -I rxy sin26 (8. 3) rO = rxy cos 28 - sin26 (8. 4) 2 2 a, - a 2 Equations (8. 3) and (8. 4) describe the stresses as a function of 8. The maximum and minimum stresses ... differentiating equation (8. 3) and equating this to zero, i.e. due - = -0, - cy sin 28 + 2rXy cos 28 = 0 d0 Hence 2Txy tan 28 = - ax - cy (8. 5) Stres...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 1 potx
... Figure 1.49 A heat engine Mechanical Engineer’s Reference Book Dynamics of rigid bodies 1/7 Figure 1.5 I Normal vx = v cos 6, vy = v sin 8, ax = a cos +, ay := ... Formerly Principal Lecturer, Department of Mechanical and Production Engineering,Preston Polytechnic Robert K. Turton BSc(Eng), CEng, MIMechE Senior Lecturer in Mechanical Engineering,...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 2 doc
... the primary coil is El = Nl(d@dt) (2 .86 ) Since the magnetic flux is common to both coils the e.m.f. induced in the secondary winding is (2 .87 ) (2 .88 ) The ratio of primary coil turns ... Clarendon Press, Oxford (1 985 ) Kaufman, M. and Seidman, A. H., Handbook of Electi,onics Calculations for Engineers and Technicians, second edition, McGraw-Hill, New York (1 988 ) Wat...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 3 ppsx
... be purchased for less than 240. This particular model comes complete with such facilities as four 8- bit I/O ports, a four- channel multiplexed 8- bit A/D converter, timers and counters, ... bi-directional 8- bit IiO ports and timers but has no ND conversion facilities. (b) The Motorola MC 687 05R3 microcontroller16 This is a powerful SCM which comprises an 8- bit CPU wit...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 4 pot
... inventory file, for example, would contain information on each part stored in a warehouse. For each part would be held such data as the part number, description, quantity in stock, quantity on ... is usually in the range 10-12 bits. i.e. a resolution of 1 part in 1024 to 1 part in 4096. Resolutions of anything from 8 to 32 bits are, however. available. Where a prog...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 5 pot
... -3 36 6 10 10 14 14 18 18 21 24 30 30 40 40 50 50 65 65 80 80 100 100 120 EO 140 140 160 160 180 180 200 200 225 2 28 280 250 280 280 315 315 355 355 400 ... 500 560 560 630 630 710 710 80 0 80 0 900 900 loo0 1m 1120 1120 1250 1750 1400 1400 1M 1M 180 0 1600 2WO 2m 2240 2240 2500 280 0 280 0 280 0 3150 Table...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 6 pps
... 2 - 12 430, 480 , 546 26 21 28 29 30 31 32 33 A27 + A1 48 430, 490, 540 A356 430, 480 , 540 430 540. 620, 690 A21 460 A356 460 460 460 460 480 A 389 480 540 540 620 ... DTD50 08 DTD50 18 so 120-150 170-200 Linear exp. coeff. 20 x 21 0-31 or ~~. 140-310TF 150-290TF 180 -310TF 130-200TF 130-210TF 180 20-3 1 TF 150-3 1 OTF 260 180...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 7 ppt
... Stainless ~ 388 0 2550 3370 2520 2470 1900 1900 1630 1200 87 40 2500 2700 7 680 1440 1140 87 90 1140 900 3120 786 0 786 0 380 164 196 390 450 340 235 980 10 124 86 75 200 ... 210 350 Specific gravity du 0 .81 8 0 .87 1 0.9 08 0.937 0.965 0.969 0.970 Viscosity (centistokes) 1.04 2.06 3 .88 10 100 350 1000 Refractive index nD 1. 382 1.39...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 9 pptx
... Mineral 011 Poor 0 .87 High Low NO NO Very good Water-in-oil emulsion Fair 0.94 High High Partly No Good Water- giycol Excellent 1. 08 High High Partly Yes Fair Phosphate ... Axial loads only Bearing applications of all kinds ( 18) to 100 (100) to 140 18 ( 18) to 100 (100) to 140 (140) to 200 (200) to 280 - - - - - - 40 (40 to 100 40 (40)...
Ngày tải lên: 11/08/2014, 15:20
Mechanical Engineer''''s Reference Book 2011 Part 11 pptx
... (mm) Y 5.3 1.6 4.7 8. 0 7.0 32 463 6.2 36 >63 6.3 z-SPZ 8. 5 2.5 9.0 12.0 8. 0 34 480 10.0 38 > ;80 10.2 A-SPA 11.0 3.3 11.0 15.0 10.0 34 41 18 13.1 38 >1 18 13.3 B-SPB 14.0 ... 157 0.94 154 0.93 151 0.93 1 48 0.92 145 0.91 142 0.90 139 0 .89 136 0 .88 133 0 .87 130 0 .86 127 0 .85 123 0 .83 120 0 .82 Nore: Arcs of contact below 120" s...
Ngày tải lên: 11/08/2014, 15:20