... 30.24 ISOLATION OF RANDOM VIBRATION In random vibration, all frequencies exist concurrently, and the amplitude and phase relations are distributed in a random manner. A trace of random vibration is ... described as narrow-band random vibration or a random sine wave. The characteristics of random vibration are defined by a frequency spectrum of power spectral density (see Chaps. 1...
Ngày tải lên: 11/08/2014, 07:23
... Harris and C. E. Crede (eds.), Shock and Vibration Handbook, ” 1st ed., vol. III, chap. 50, McGraw- Hill Book Company, Inc., New York, 1961. 7. Richart, F. E., Jr., J. R. Hall, Jr., and R. D. ... M.: Shock and Vibration Handbook, ” 3d ed., McGraw-Hill Book Company, Inc., New York, 1988. [See also 1st (1961) and 2d (1976) eds.] 21. Stevenson, J. D., W. J. Hall, et al.: “Stru...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 14 docx
... for Improv- ing Vehical Noise and Vibration, ” SAE Paper 880073 International Congress and Exposi- tion, Detroit, Mich., Feb. 29, 1988. SHOCK AND VIBRATION ISOLATORS AND ISOLATION SYSTEMS 32.41 8434_Harris_32_b.qxd ... elastic and viscous. Rubber parts can there- fore function as shock and vibration isolators and/ or as dampers. Although the term rubber is used rather lo...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 1 ppt
... computer technologies, new methods of shock and vibration control, new instrumentation, and new materials and techniques used in controlling shock and vibration. Many new standards and test codes have also ... discusses methods of controlling shock and vibration, and the design of equipment for shock and vibration environments. A final chapter presents the effect...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 2 doc
... value, and increases continuously at a slow rate. The amplitude of the vibration p ᎏ m NONLINEAR VIBRATION 4.7 FIGURE 4.10 Period of free vibration of a simple pendulum according to Eq. (4.3) and showing ... Chap. 39). If the bearings are a distance l apart and the dynamic reactions F x and F y are measured, the products of inertia are 2I xz ᎏ I zz − I xx VIBRATION OF A RESILI...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 3 ppt
... Systems,” J. of Vibration and Acoustics, 117(B):117–161, 1995. 5. Choi, Y. S., and S. T. Noah: “Forced Periodic Vibration of Unsymmetric Piecewise-Linear Systems,” J. of Sound and Vibration, 121(3):117–126, ... Rubs and Chatter Instabilities in Forced Vibrations Bistable vibration Unstable imbalance In each instance, the physical mechanism is described and aspects of its prev...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 4 doc
... 41:744 (1921); 43:125 (1922). 11. Sutherland, J. G., and L. E. Goodman: “Vibrations of Prismatic Bars Including Rotatory Inertia and Shear Corrections,” Department of Civil Engineering, University ... X and Y directions, respectively. In each mode there are m − 1 evenly spaced nodal lines parallel to the Y axis, and n − 1 parallel to the X axis. Rayleigh’s and Ritz’s Methods. The mo...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 6 pps
... compensate for time delay VIBRATION MEASUREMENT INSTRUMENTATION 13. 13 8434_Harris _13_ b.qxd 09/20/2001 11:14 AM Page 13. 13 typical capacitance pickup; Fig. 12.33B, C, D, and E show a number of possible methods ... C i − C f (A − 1) 13. 2 CHAPTER THIRTEEN FIGURE 13. 1 A block diagram of a typical vibration measurement system. FIGURE 13. 2 Diagram of a charge amplifier with accele...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 7 ppt
... vanes and blades in pumps and fans, number of motor poles, and number of stator slots and rotor bars. ● Vibratory forces such as misalignment, mass unbalance, and reciprocating masses. ● Vibration ... Piersol, J. H.Wise, and M. R. Grundrig (eds.): Handbook for Dynamic Data Acquisition and Analysis,” IEST Recommended Practice DTE012.1, Institute of Envi- ronmental Sciences an...
Ngày tải lên: 11/08/2014, 07:23
Harris'''' Shock and Vibration Handbook Part 8 pdf
... R. R. “Calibration of Shock and Vibration Measuring Transducers,” Shock and Vibration Monograph SVM-11,The Shock and Vibration Information Center,Washington, D.C., 1979. 13. Ge, L F.: “The Reciprocity ... shock and vibration. ISO TC 108/SC 2 (Measurement and Evaluation of Mechanical Vibration and Shock as Applied to Machines, Vehicles, and Structures) is invo...
Ngày tải lên: 11/08/2014, 07:23