Air Sampling and Industrial Hygiene Engineering - Chapter 8 pptx

Air Sampling and Industrial Hygiene Engineering - Chapter 8 pptx

Air Sampling and Industrial Hygiene Engineering - Chapter 8 pptx

... fluid intake, and monitoring employees for symptoms, especially high-risk workers. 8. 3.4.2 Air Sampling and Monitoring Example General hazards frequently encountered during air sampling and monitoring ... are located 8. 1.3.2 Perimeter Reconnaissance Research previous soil surveys, ground-penetrating radar and manometer data, and air sampling and monitoring data. Mo...
Ngày tải lên : 11/08/2014, 06:22
  • 35
  • 425
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 1 pps

Air Sampling and Industrial Hygiene Engineering - Chapter 1 pps

... Decay 8. 4.3 Activity 8. 4.4 Decay Law 8. 4.5 Half-Life 8. 4.6 Types of Ionizing Radiation 8. 4.6.1 Alpha Particles 8. 4.6.2 Beta Particles 8. 4.6.3 Gamma Rays 8. 4.6.4 X-rays 8. 4.7 Rules of Thumb 8. 4 .8 ... Cataloging-in-Publication Data Boss, Martha J. Air sampling and industrial hygiene engineering / Martha J. Boss, Dennis W. Day. p. cm. Includes bibliographical re...
Ngày tải lên : 11/08/2014, 06:22
  • 25
  • 385
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 2 pdf

Air Sampling and Industrial Hygiene Engineering - Chapter 2 pdf

... or on-site immunoassay testing must be accomplished. Therefore, until results are obtained and inter- preted, on-site personnel would be required to wear HEPA-OV cartridge full- face air- purifying ... l/min. High-flow pumps are used for asbestos, PAHs in indoor air, PM10 and PM2.5 in indoor air, bioaerosol sampling, stack sampling, fenceline monitoring, and background monitoring....
Ngày tải lên : 11/08/2014, 06:22
  • 69
  • 986
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 3 potx

Air Sampling and Industrial Hygiene Engineering - Chapter 3 potx

... Secondary standard rotameters are used in the field to calibrate air- sampling pumps. Rotameters are calibrated to a primary standard. Flow rates must be corrected for stan- dard temperature and pressure. ... Press LLC Figure 3 .8 An electronic adapter is available to automatically calibrate an air sampling pump. (SKC—AirCheck ® 2000 air sampling pump, CalCheck ® Communicator w...
Ngày tải lên : 11/08/2014, 06:22
  • 12
  • 337
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 4 pps

Air Sampling and Industrial Hygiene Engineering - Chapter 4 pps

... air sampling and air sample analysis, bulk sampling and bulk sample analysis, and negative air pressure maintenance. Personnel records include résumés, certifications, medical surveillance, and ... sample. The sampling may be for a full-shift sample or for a short period ceiling determination. 4.5.2 Full-Period, Consecutive Sampling Full-period, consecutive sampling is...
Ngày tải lên : 11/08/2014, 06:22
  • 17
  • 435
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 5 docx

Air Sampling and Industrial Hygiene Engineering - Chapter 5 docx

... worst-case scenario for soils and are evalu- ated using log-normal distribution, Kriging, or Monte Carlo analysis. Ground- and surface-water samples are collected (20 samples per location) and ... and engineering controls may require air monitoring of personnel, area of influence, and the site perimeter. In order to understand the context under which air monitoring protocols...
Ngày tải lên : 11/08/2014, 06:22
  • 10
  • 239
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 6 ppt

Air Sampling and Industrial Hygiene Engineering - Chapter 6 ppt

... Acombination of contact and air- sampling information is required to assess most buildings (Figure 6.1), and these acceptable numbers vary given different biological con- taminant mixes and building usage. ... Epidermophyton, Microsporum, and Trichophyton Skin, hair, and nail infections by these dermatophytid molds are among the most prevalent of human infections. Agents are pres...
Ngày tải lên : 11/08/2014, 06:22
  • 15
  • 324
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 7 pps

Air Sampling and Industrial Hygiene Engineering - Chapter 7 pps

... Barometric pressure and air temperature should be noted when using air veloc- ity meters. © 2001 CRC Press LLC designed in accordance with ASME B19. 1-1 985 and B19.1a-1 985 , Safety Standards for Compressor ... ASHRAE handbook, ASHRAE Standard 62, and the requirements of NFPA Standards Nos. 90A, 90B, and 91. Motorized low-leakage dampers, with blade and jamb seals, should be...
Ngày tải lên : 11/08/2014, 06:22
  • 19
  • 460
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 9 pps

Air Sampling and Industrial Hygiene Engineering - Chapter 9 pps

... minimum site-specific, task-specific, and hazard-specific proce- dures, precautions, and equipment determined necessary and described in the HSDA are clearly biddable and enforceable contractual requirements ... containers, and training for employees. There must be open communica- tion between all parties involved with hazardous material, including employer-employee, employee-employ...
Ngày tải lên : 11/08/2014, 06:22
  • 12
  • 357
  • 0
Air Sampling and Industrial Hygiene Engineering - Chapter 11 pps

Air Sampling and Industrial Hygiene Engineering - Chapter 11 pps

... (hazardous waste operations and emergency response), 29 CFR 1926. 58 (asbestos, tremolite, antho- phylite, and actinolite), 29 CFR 1910.10 28 (benzene), 29 CFR 1910.1027 (cadmium), and any other situations ... headaches, and vomiting. High exposures may cause convulsions and coma and irregular heartbeat. Repeated exposure can damage the blood-forming organs, caus- ing aplastic a...
Ngày tải lên : 11/08/2014, 06:22
  • 12
  • 312
  • 0

Xem thêm

Từ khóa: