Vision Systems - Applications Part 11 docx
... With 22 x x x 22 x x * x xxx 1+x ( 1- (DŽ +Ǐ))+y - Ǐxy xDŽ DŽ +Ǐ 1+y ( 1- (DŽ +Ǐ))+x 1 Ǐxy - yDŽ ǔǒ DŽ +Ǐ Lj x Lj y (Lj -1 )Ǐ A ªº «» «» «» «» = «» «» «» «» ¬¼ and 22 x x 22 x x (1+x )DŽ - y x yy DŽ +Ǐ (1+y )DŽ - x -x y -x DŽ +Ǐ 000 B ª º « » « » « » « » = « » « » « » « » ¬ ¼ Where: ... reach the desired images. Figures 5(e) and 5(f) Vision Systems: Applications 430 A B Figur...
Ngày tải lên: 11/08/2014, 06:21
... set of robust visual part. Motivated by these facts, many computational models were proposed in computer vision. Researchers of model-based vision regarded bottom-up/top-down processes as hypothesis/verification ... representation. Vision Systems: Applications 164 4.3 View-based model representation Basically, the HVS memorizes objects in an orientation dependent, view-based or...
Ngày tải lên: 11/08/2014, 06:21
... evolutionary algorithms, biogeography-based optimization (BBO) and estimation-of-distribution algorithm (EDA), to this MD-STBC-MIMO detection problem. The MD-STBC-MIMO detection problem is converted ... for 2Tx-2Rx and 4Tx-2Rx antenna configurations. QPSK and 16-QAM constellations are used in the simulations. The 2Tx-2Rx system uses the 2-bit Grassmannian codebook ([Love & Heath (2003)]-...
Ngày tải lên: 21/06/2014, 03:20
Tài liệu Fourier and Spectral Applications part 11 docx
... 0.188176800078, 0.5272 0118 8932, 0.688459039454, 0.2 8117 2343661 ,-0 .249846424327, -0 .195946274377, 0.127369340336, 0.093057364604, -0 .071394147166 ,-0 .029457536822, 0.033212674059, 0.003606553567 ,-0 .010733175483, ... Spectral Applications Sample page from NUMERICAL RECIPES IN C: THE ART OF SCIENTIFIC COMPUTING (ISBN 0-5 2 1-4 310 8-5 ) Copyright (C) 198 8-1 992...
Ngày tải lên: 26/01/2014, 14:20
Heat Transfer Engineering Applications Part 11 docx
... four steels designated as HP 9-4 -2 0, HP 9-4 -2 5, HP 9-4 -3 0 and HP 9-4 -4 5 nominally have 0.20, 0.25, 0.30 and 0.45%C respectively. Among these steels, HP 9-4 -2 0 and HP 9-4 -3 0 are produced in significant ... strength (MPa) Elongation (%) Hardness (HRc) Izod impact (J) HP 9-4 -2 0 1380 - - - - HP 9-4 -3 0 1650 1350 14 49 - 53 39 Ta...
Ngày tải lên: 19/06/2014, 10:20
Advanced Radio Frequency Identification Design and Applications Part 11 docx
... discusses sensor systems used in the mobile robot localization. Then the advantages of the RFID systems as sensor systems for localization are discussed and the researches on the systems are reviewed. ... RFID systems for indoor mobile robots The RFID based localization systems are also used by several researches to localize the indoor mobile robots. The RFID systems as localiza...
Ngày tải lên: 19/06/2014, 23:20
Mechatronic Systems Applications Part 11 pptx
... Vol. 11, No. 6, 67 1-6 81. Ando, Y. & Ino, J. (1997). The effect of asperity array geometry on friction and pull-off force, Transactions of the ASME Journal of Tribology, Vol. 119 , 78 1-7 87. ... Conference on Robotics and Automation, Vol. 1, 84 6-8 51 Doi, T, (2001), Feedback control for electromagnetic vibration feeder (Applications of two- degrees-of-freedom proportional...
Ngày tải lên: 21/06/2014, 11:20
Mechatronic Systems Applications Part 14 docx
... pp. 1 4-2 9, ISSN 074 9-7 075. Bucher, P.G. & Lee, G.L. (2000). Competitiveness Strategies and AMT Investment Decisions. Integrated Manufacturing Systems, No. 11/ 5, pp. 34 0-3 47, ISSN 095 7-6 061. ... Engineering (ICOSSE’06), Tenerife, Canary Islands, Spain, WSEAS Press, pp. 41 2-4 16, ISBN 96 0-8 45 7-5 7-2 , ISSN 179 0-5 117 . Hynek, J. & Janeček, V. (2007...
Ngày tải lên: 21/06/2014, 11:20
Petri nets applications Part 11 docx
... controller) t 1-2 1=-b 1-3 t 1-1 00=b 1-3 ,-b 1-4 t 1-7 1=b 1-4 , -b 1-5 t 1-1 01=b 1-5 , -b 1-6 t 1-8 1=b 1-6 , -b 1-7 t 1-3 1=b 1-7 t 1-4 1=-b 1-1 3 t 1-1 02=b 1-1 3,-b 1-1 4 t 1-9 1=b 1-1 4, -b 1-1 5 t 1-1 03=b 1-1 5, -b 1-1 6 t 1-5 1=b 1-1 6 (MC ... t 2-2 2=-b 2-8 t 2-2 00=b 2-8 , -b 2-9 t 2-8 2=b 2-9 , -b 2-1...
Ngày tải lên: 21/06/2014, 11:20
Volume 07 - Powder Metal Technologies and Applications Part 11 docx
... Fe-5Cr-1.5Mo-1Si-1V-0.4Mn-0.4C 50 Larger or intricate cavities, high toughness, low wear M2 tool Fe-6W-5Mo-4Cr-2V-0.3Mn-0.8C 61 Core and ejector pins P20 steel Fe-1.7Cr-0.8Mn-0.5Mo-0.4V-0.35C ... 1 7-4 PH (HT) Fe-16Cr-4Ni-4Cu 96 965 114 0 12 35 HRC Stainless 316L Fe-17Cr-12Ni-2Mo-2Mn 96 220 510 45 75 HRB Stainless 420 (HT) Fe-13Cr-1Mn-1Si 92 690 1440 6 47 HRC Stellite Co...
Ngày tải lên: 10/08/2014, 12:22