McGraw-Hill - The Robot Builder''''''''s Bonanza Episode 2 Part 12 pot
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 12 pot
... in, 26 5 26 8 odometry with, 27 0 27 6, 628 –631 power MOSFET for, 26 2 relay control in, 25 5 torque in, 24 0 24 2 transisitor control of, 25 7 26 2 travel speed of, 23 1 versus other motor types, 23 5 23 7 differential ... 94903 (415) 49 1-4 600 www.robotstore.com Mr. Robot 8 822 Trevillian Road Richmond, VA 23 235 (804) 27 2- 5 7 52 www.mrrobot.com Norland Research 8475 L...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 7 potx
... applied to the input of the HT-12D encoder. The Holtek Web page provides data sheets and circuit recommendations for the HT-12D chip. There are five important outputs for the HT-12D: the four data ... of conversion Clk Ale 11 Vcc OE 22 9 +Rf 12 Gnd 13 -Ref 16 25 24 23 6 7 10 A B To ADC input ( 0-7 ) +V 10K Foam transducer FIGURE 35.7 a. The basic wiring diagram for con...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 3 doc
... 1 / 2- inch-by-1 / 2- inch corner angle iron 1 3 1 / 2- inch-by-1/4-inch 20 stove bolt 2 1/4-inch 20 locking nuts, nuts, washers, tooth lock washers 2 1 / 2- inch-by-8/ 32 stove bolts, nuts, washers 1 1-inch-diameter ... DESIGNS TABLE 27 .3 PARTS LIST FOR WORM DRIVE GRIPPER. 2 3-inch lengths 41/64-inch-by-1 / 2- inch-by-1/16-inch aluminum channel 2 1-inch-diameter 64-pitch plastic...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 4 docx
... outputs +5V 21 MSB LSB 20 19 18 Q1 Q7 Q6 Q5 Q4 Q3 8 Q2 15 14 Q0 17 IN1 IN0 IN2 IN3 IN4 IN5 IN6 IN7 26 27 28 1 2 3 4 5 1 2 3 4 5 6 7 0 A1 A2 A4 Sc Start Conversion Eoc End of conversion Clk 500kHz In Ale 11 Vcc OE 22 9 +Rf 12 Gnd 13 -Ref 16 25 24 23 6 7 10 FIGURE ... the demux outputs and have 474 COMPUTER CONTROL VIA PC PRINTER PORT +5vdc 24 Vcc 19 Enable 12 Gnd 1...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 5 pptx
... of the robot. You should not rely on the BX -2 4 ’s on-board regulator for this task. Pinout Diagram for the BX -2 4 Fig. 32. 2 shows the pinout diagram of the BX -2 4 as well as the functions of its 24 ... name PROGRAMMING THE BX -2 4 505 FIGURE 32. 3 The easiest way to experiment with the BX -2 4 is to use the carrier board that is included as part of the BX -2 4...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 6 ppt
... USING THE BASICX MICROCONTROLLER 10K To BasicX -2 4 I/O pin 20 +5 vdc (from BX -2 4 carrier board) (ground from BX -2 4 carrier board) FIGURE 32. 5 Wire the switch so it con- nects to the Vϩ (pin 21 , not ... to the reference voltage. The Operate property of the oA2D object initi- ates the conversion, and the Value property is updated with the result of the conversion...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 8 pdf
... object. So-called “bumper switches” are spring-loaded push-button switches mounted on the frame of the CONTACT DETECTION 581 +12V 8 1 4 3 2 7 6 Q1 2N 222 2 e b c IC1 555 About 40 kHz R3 1.2K R4 2. 2K Ultrasonic Transducer C2 0.1 C1 0.0033 R2 5K R1 1K FIGURE ... DETECTION OUT 10 1 2 3 4 5 6 7 8 10 11 12 9 13 14 15 0 7 6 5 4 3 2 1 23 22 21 20 19 18 17 16 8 9 ENABLE 15 +5VDC O...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 9 pps
... note your results. USING THE GP2D 12 ANALOG OUTPUT INFRARED RANGING SENSOR The GP2D 12 is similar to the GP2D 02 of the last section, except that it provides an analog output rather than a digital one. ... NAND gate. Before using the robot, block the phototransistors so they don’t receive any light. Rotate the shaft of the set-point pots until the relays kick in, then...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Episode 2 Part 10 pdf
... adjusting the sensitivity of the input amplifier and decreasing the bandwidth of the chip. 674 SOUND OUTPUT AND INPUT MIC1 RED 0.4 7 -2 .2 C2 R1 500K 6 7 4 2 3 e c b Output R4 1K +5VDC R3 2N 222 2 Q1 - + IC1 741 C1 0.47 R2 6.8K R5 1K 6.8K FIGURE ... instead of the rule. The companies that made stand-alone speech synthesizer chips either stopped manufacturing them or were t...
Ngày tải lên: 10/08/2014, 04:22
McGraw-Hill - The Robot Builder''''s Bonanza Part 2 pptx
... assortment of the small PC-mount pots (about 80 cents each retail) in the 1-megohm and 2. 5K-, 5K-, 10K-, 50K-, 100K-, 500K-, and 25 0K-ohm values. You’ll find that 500K-ohm and 1-megohm pots are often ... Get the plain stuff: it’s 10 to 25 percent cheaper. Two particularly handy stocks are 41/64-by-1 / 2- by-1/16-inch channel and 57/64-by- 9/16-by-1/16-inch channel. I use these exte...
Ngày tải lên: 10/08/2014, 04:22