Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 5 ppt
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 5 ppt
...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 13 ppt
...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 9 pptx
...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 11 pptx
... 16 3 8 35 5 10 A 15 A 15 36 1 5 4 A14 37 26 3 A13 38 2 2 A12 39 23 40 21 41 24 42 25 44 8 45 46 9 4748 10 4 950 11 34 11 7 29 Ti3 26 25 D5 24 D4 23 D3 22 D2 52 5 11 9 20 10 21 10 11 12 13 14 15 43 2728 ... 4 U7/74HC132 PD0/RxD IRQ XIRQ RESET PC7 /AD7 PC6 /AD6 PC5 /AD5 PC4 /AD4 PC3 /AD3 PC2 /AD2 PC1 /AD1 PC0 /AD0 XTAL PA0/IC3 PB7/A 15 PB6/A14 PB5/A13 PB4/A12 PB3/A11 PB2...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 2 pdf
... Good BadBad Ugly Pin 1 Pin 7 Pin 8Pin 14 Notch marking M Motorola 68HC11A0 Pin 1 Marking Soldering iron positioned so that tip touches both the pad on the PC board and the component lead coming ... h18" alt="" Good Bad Ugly If you feed the solder into the soldering iron rather than the joint, the solder will ball up, refusing to bond with the improperly heated PC board pad.
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 3 doc
...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 4 pps
... SCHEMATIC +5v gnd 8-tooth gear attached to motor shaft Polaroid motor 2x4 LEGO plate glued to motor Gear center perfectly aligned with LEGO hole 24 24 Polaroid motor LEGO Jig, side view LEGO Jig, ... Plug +5v ground signal
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 8 pot
...
Ngày tải lên: 10/08/2014, 02:20
Robot Building Manual Full With Electronic Ad Stepper Motor Teknik Part 8 pdf
...
Ngày tải lên: 10/08/2014, 02:20