GasTurbine Engineering HandbookSecond Edition phần 8 pptx

GasTurbine Engineering HandbookSecond Edition phần 8 pptx

GasTurbine Engineering HandbookSecond Edition phần 8 pptx

... compliance characteristics of the rotor. 594 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 16.3D ± 5 78 ± [5 58 583 /26] 29.10.2001 4:05PM vibration also exists that ... compressor shows details of critical frequencies. 5 78 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 17.3D ± 589 ± [ 584 ±604/21] 29.10.2001 4:06PM Fig...

Ngày tải lên: 08/08/2014, 17:20

82 270 0
GasTurbine Engineering HandbookSecond Edition phần 3 pptx

GasTurbine Engineering HandbookSecond Edition phần 3 pptx

... system with viscous damping is given here. 182 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 5.3D ± 184 ± [1 78 2 18/ 41] 29.10.2001 3:57PM The nature of the solution ... is the minimum a user needs for safe 160 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 5.3D ± 182 ± [1 78 2 18/ 41] 29.10.2001 3:57PM degree of freedom...

Ngày tải lên: 08/08/2014, 17:20

82 226 0
GasTurbine Engineering HandbookSecond Edition phần 7 pptx

GasTurbine Engineering HandbookSecond Edition phần 7 pptx

... directly on a pad or to occur between pads. Bearings and Seals 483 //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 14.3D ± 521 ± [521±5 38/ 18] 29.10.2001 4:05PM 14 Gears Gearing is one of the most important ... pads do not aid in resisting cross-coupling influences. 484 Gas Turbine Engineering Handbook G:/GTE/FINAL (26-10-01)/CHAPTER 13.3D ± 5 18 ± [467±520/54] 1.11.2001 3:56PM narrow se...

Ngày tải lên: 08/08/2014, 17:20

82 200 0
GasTurbine Engineering HandbookSecond Edition phần 1 pot

GasTurbine Engineering HandbookSecond Edition phần 1 pot

... bed 1200±1400 7300±7701 47 7.0 1.45 75 85 % 90±95% 30±36 Nuclear power 180 0±200 10000±10550 34 8 2. 28 80 89 92± 98% 48 60 Steam plant coal fired 80 0±1000 9749±10 285 35 3 1.43 82 89 % 94±97% 36±42 Diesel generator-diesel fired 400±500 ... (2500  F/1371  C) natural gas fired 300±350 7 582 80 00 45 5 .8 0.23 88 ±95% 97±99% 10±12 Simple cycle gas turbine oil fired 400±500 83 22 82 2...

Ngày tải lên: 08/08/2014, 17:20

79 249 0
GasTurbine Engineering HandbookSecond Edition phần 2 doc

GasTurbine Engineering HandbookSecond Edition phần 2 doc

... 3,743,3 08 2,291,365 6,034,672 Heated and humidified compressed air injection 23.44 21.12 21.23 9,020 3.7 157 .84 5,597, 388 3,3 68, 355 8, 965,744 Steam injection 10.11 9.11 22.13 89 54 1.7 1 68. 19 5,220,193 ... 22.13 89 54 1.7 1 68. 19 5,220,193 1,466,792 6, 686 , 985 Evaporative cooling  Steam injection 13.97 12.59 24.02 88 17 2.1 150.34 5,770,444 2,0 68, 616 7 ,83 9,060 Theoretica...

Ngày tải lên: 08/08/2014, 17:20

82 273 0
GasTurbine Engineering HandbookSecond Edition phần 4 doc

GasTurbine Engineering HandbookSecond Edition phần 4 doc

... removed from the projected design condition. 240 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 6.3D ± 2 38 ± [219±274/56] 29.10.2001 3:59PM where V 2 is the tangential ... is changed. Figure 6-21. Forces and flow characteristics in a centrifugal compressor. 2 38 Gas Turbine Engineering Handbook //INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 6.3D ± 259...

Ngày tải lên: 08/08/2014, 17:20

82 172 0
GasTurbine Engineering HandbookSecond Edition phần 5 potx

GasTurbine Engineering HandbookSecond Edition phần 5 potx

... predominate frequencies of 48N existed up to speeds of 680 0 rpm. At 84 00 rpm, the 48N and 86 N frequencies were of about equal magnitudesÐthe only signal where the 48N and 86 N frequen- cies were the ... Journal of Engineering for Power, ASME Trans., Vol. 86 , Series A, p. 227.) Radial-Inflow Turbines 321 //SYS21///INTEGRA/B&H/GTE/FINAL (26-10-01)/CHAPTER 8. 3D ± 332 ± [319±336/...

Ngày tải lên: 08/08/2014, 17:20

82 251 0
GasTurbine Engineering HandbookSecond Edition phần 6 doc

GasTurbine Engineering HandbookSecond Edition phần 6 doc

... –3 CrMoV IN-706 A- 286 M-152 TEMP °C TEMP °F 140 120 100 80 60 10.0 8. 0 6.0 4.0 0 100 200 300 500 200 400 600 80 0 1000 400 Figure 11-7. Turbine Wheel Alloys tensile yield strength comparison. 426 Gas Turbine Engineering ... BAL 9.5 Â ± 3 .8 1.5 4.9 3.0 Â ± Â ± 0.10 0.01 2 .8 Turbine Nozzles X40 25 10 BAL 1 8 Â ± Â ± Â ± Â ± Â ± 0.50 0.01 Â ± X45 25 10 BAL 1 8 Â ± Â ± Â ± Â ± Â...

Ngày tải lên: 08/08/2014, 17:20

82 289 0
GasTurbine Engineering HandbookSecond Edition phần 9 pot

GasTurbine Engineering HandbookSecond Edition phần 9 pot

... T 2 Sensitivity (%) 6 0.704 0.2 18 7 0.750 0.231 8 0. 788 0.240 9 0 .82 0 0.250 10 0 .84 8 0.260 11 0 .87 3 0.265 12 0 .89 5 0.270 13 0.906 0.277 14 0.933 0. 282 15 0.9 48 0. 287 16 0.963 0.290 Tabulation showing ... frequency; harmonics may or may not exist. 688 Gas Turbine Engineering Handbook G:/GTE/FINAL (26-10-01)/CHAPTER 19.3D ± 6 68 ± [634±691/ 58] 1.11.2001 2:38PM 2. Compres...

Ngày tải lên: 08/08/2014, 17:20

82 188 0
GasTurbine Engineering HandbookSecond Edition phần 10 docx

GasTurbine Engineering HandbookSecond Edition phần 10 docx

... above 100 MW have availability factors of 85 Â 89 %. The bigger units produce twice the output, but the avail- ability factor has decreased from 95% to 85 %. A decrease of 7 Â ±10 points for all ... costs. 96 35 85 45 0 10 20 30 40 50 60 70 80 90 100 Below 100 MW Above 100 MW Availability Efficiency Figure 21-5. Comparison of availability and efficiency for large frame type gas turbin...

Ngày tải lên: 08/08/2014, 17:20

78 195 1
Từ khóa:
w