biến tần delta phần 10 docx

... Message type Network Management (NMT) Baud rate 10 Kbps 20 Kbps 50 Kbps 125 Kbps 250 Kbps 500 Kbps 800 Kbps 1 Mbps Product code Delta VFD-EL AC motor drive 22 Device type 402 Vendor ... Environmental Specifications Noise Immunity ESD(IEC 61131-2, IEC 6100 0-4-2): 8KV Air Discharge EFT(IEC 61131-2, IEC 6100 0-4-4): Power Line: 2KV, Digital I/O: 1KV, Analog & Communi...

Ngày tải lên: 07/08/2014, 23:20

... Pr.07.14= V +10 * (R PTC1 //47K) / [R1+( R PTC1 //47K)] 2. Warning level Pr.07.16= V +10 * (R PTC2 //47K) / [R1+( R PTC2 //47K)] 3. Definition: V +10: voltage between +10V-ACM, Range 10. 4~11.2VDC ... below shows I 2 t curves for 150% output power for 1 minute. 350 50Hz or more 10Hz 5Hz 05 0100 150 250200 300 250 200 150 100 50 Operation time (seconds) Load factor (%) Chapte...

Ngày tải lên: 07/08/2014, 23:20

... P/N: BR500W030, BR500W100, BR1KW020, BR1KW075 Model no. L1 L2 H D W Max. Weight (g) BR500W030 BR500W100 335 320 30 5.3 60 1100 BR1KW020 BR1KW075 400 385 50 5.3 100 2800 Appendix A Specifications| ... 20 JJN-20 VFD007EL23A 4.9 4.2 10 JJN -10 VFD007EL43A 3.2 2.5 5 JJS-6 VFD015EL21A 15.7 7.5 30 JJN-30 VFD015EL23A 9 7.5 20 JJN-20 VFD015EL43A 4.3 4.2 10 JJS -10 VFD022EL21A 24...

Ngày tải lên: 07/08/2014, 23:20

... programming +10V Potentiometer power supply +10VDC 3mA AVI Analog voltage Input ACM AVI +10V internal circuit AVI circuit Impedance: 47kΩ Resolution: 10 bits Range: 0 ~ 10VDC = 0 ~ ... 2-3 AVI A CI/AVI ACM +10V 5K 3 2 1 Figure 1 for models of VFD-EL Series VFD002EL11A/21A, VFD004EL11A/21A, VFD007EL11A/21A, VFD015EL21A, VFD022EL21A Power supply +10V 3mA Master Frequency 0 to 10V...

Ngày tải lên: 07/08/2014, 23:20

... 120.0% 110. 0 01.08 Output Frequency Lower Limit 0.0 to100.0 % 0.0 01.09 Accel Time 1 0.1 to 600.0 / 0.01 to 600.0 sec 10. 0 01 .10 Decel Time 1 0.1 to 600.0 / 0.01 to 600.0 sec 10. 0 01.11 ... 0~9999(*2ms) 100 07.14 Motor PTC Overheat Protection Level 0.1 ~10. 0V 2.4 07.15 Motor PTC Overheat Warning Level 0.1 ~10. 0V 1.2 07.16 Motor PTC Overheat Reset...

Ngày tải lên: 07/08/2014, 23:20

... 20mA) 0 10. 02 Proportional Gain (P) 0.0 to 10. 0 1.0 10. 03 Integral Time (I) 0.00 to 100 .0 sec (0.00=disable) 1.00 10. 04 Derivative Control (D) 0.00 to 1.00 sec 0.00 10. 05 Upper ... and COAST to stop 10. 09 Treatment of the Erroneous PID Feedback Signals 2: Warn and keep operation 0 10. 10 Gain Over the PID Detection Value 0.0 to 10. 0 1.0 10. 1...

Ngày tải lên: 07/08/2014, 23:20

... REV motion enabled Gain:(10V/10V) *100 % =100 % Bias adjustment:((60Hz/60Hz)/(Gain /100 %)) *100 % =100 % negative slope 04.11 Minimum AVI Voltage Unit: 0.1 Settings 0.0 to 10. 0V Factory Setting: 0.0 04.12 ... =83.3% Input gain Pr.04.03 =0 No negative bias command Gain:(10V/(10V+2V)) *100 %=83.3% Bias adjustment:((10Hz/60Hz)/(Gain /100 %)) *100 %=20.0% 10Hz Bias Adjustment -2V XV...

Ngày tải lên: 07/08/2014, 23:20

... 4-95 Content Address Function 2104 H Output current (AXX.X) 2105 H Reserved 2106 H Reserved 2107 H Reserved 2108 H DC-BUS Voltage (UXXX.X) 2109 H Output voltage (EXXX.X) 210AH Display temperature ... controlled by analog signal Bit 10 1: Operation command controlled by communication interface 2101 H Bit 11-15 Reserved 2102 H Frequency command (F) 2103 H Output frequ...

Ngày tải lên: 07/08/2014, 23:20

... 4-99 Group 10: PID Control 10. 00 PID Set Point Selection Factory Setting: 0 Settings 0 Disable 1 Digital keypad UP/DOWN keys 2 AVI 0 ~ +10VDC 3 ACI 4 ~ 20mA 4 PID set point (Pr .10. 11) 10. 01 ... low speeds for long time. Chapter 4 Parameters| Revision June 2007, 0ELE, V1.00 4 -103 10. 16 10. 15 01.05 10. 14 Frequency The limit of decel. time frequency calculated by P...

Ngày tải lên: 07/08/2014, 23:20