biến tần delta phần 6 docx

... 0 Weights Bit 0=N.O 1=N.C MI1 MI2 MI3 MI4 MI5 MI6 The setting value = bit5x2 +bit4x2 +bit2x2 542 = 1x2 +1x2 +1x2 542 =32+ 16+ 4 Setting 04.09 =52 NOTE: 2 = 163 84 2 =8192 2 =40 96 2 =2048 2 =1024 2 =512 2 =2 56 2 =128 2 =64 2 =32 2 = 16 2 =8 ... Parameters| 4 -66 Revision June 2007, 0ELE, V1.00 Group 6: Protection Parameters 06. 00 Over-Voltage Stall Prevention Unit: 0.1 Settings 115...

Ngày tải lên: 07/08/2014, 23:20

... VFD002EL11A 6. 4 1 .6 15 JJN-15 VFD002EL21A 4.9 1 .6 10 JJN-10 VFD002EL23A 1.9 1 .6 5 JJN -6 VFD004EL11A 9 2.5 20 JJN-20 VFD004EL21A 6. 5 2.5 15 JJN-15 VFD004EL23A 2.7 2.5 5 JJN -6 VFD004EL43A ... Weight (g) BR080W200 BR080W750 140 125 20 5.3 60 160 BR300W100 BR300W250 BR300W400 215 200 30 5.3 60 750 BR400W150 BR400W040 265 250 30 5.3 60 930 Appendix B Accessori...

Ngày tải lên: 07/08/2014, 23:20

... 0ELE, V1.00 460 V, 50 /60 Hz, 3-Phase Inductance (mH) kW HP Fundamental Amps Max. continuous Amps 3% impedance 5% impedance 0.4 1/2 2 3 20 32 0.75 1 4 6 9 12 1.5 2 4 6 6.5 9 2.2 3 ... code Delta VFD-EL AC motor drive 22 Device type 402 Vendor ID 477 Environmental Specifications Noise Immunity ESD(IEC 61 131-2, IEC 61 000-4-2): 8KV Air Discharge EFT(IEC 61 13...

Ngày tải lên: 07/08/2014, 23:20

... (w/m. o C) Nhiệt trở [δ/λ] ( o C.m 2 /w) Sắt tây Thủy tinh 0,24 – 0, 26. 10 -3 2 - 6. 10 -3 46 - 52 0 ,6 - 0,9 4 ,6 - 7,8.10 -5 200 - 1000.10 -5 (Nguyễn Vân Tiếp. 2000) Nhưng trong quá ... triển trong thực phẩm có pH < 4 ,6. Vì vậy, pH : 4 ,6 được chọn là ranh giới phân chia giữa thực phẩm acid và ít acid. - Trong thực phẩm acid (pH < 4 ,6) bào tử Clostridium botul...

Ngày tải lên: 23/07/2014, 12:21

... T/L3 A U/T1, V/T2, W/T3, 14.2- 16. 3kgf-cm (12-14in- lbf) 12-18 AWG. (3.3- 0.8mm 2 ) Copper only, 75 o C R/L1, S/L2, T/L3 U/T1, V/T2, W/T3 B +, -, 16. 3- 19.3kgf-cm (14-17in- lbf) 8-18 ... control terminals RS-485 10VMI1 MI3 MI524V AVI RA RB RC MI2 MI4 MI6 DCM ACMAFM Frame Torque Wire A, B 5.1-8.1kgf-cm (4.4-7in-lbf) 16- 24 AWG. (1.3-0.2mm 2 ) NOTE Frame A: VFD002EL...

Ngày tải lên: 07/08/2014, 23:20

... 0.1 to 60 0.0 / 0.01 to 60 0.0 sec 10.0 01.10 Decel Time 1 0.1 to 60 0.0 / 0.01 to 60 0.0 sec 10.0 01.11 Accel Time 2 0.1 to 60 0.0 / 0.01 to 60 0.0 sec 10.0 01.12 Decel Time 2 0.1 to 60 0.0 / ... 2 0.1 to 60 0.0 / 0.01 to 60 0.0 sec 10.0 01.13 Jog Acceleration Time 0.1 to 60 0.0 / 0.01 to 60 0.0 sec 1.0 01.14 Jog Deceleration Time 0.1 to 60 0.0 / 0.01 to 60 0.0...

Ngày tải lên: 07/08/2014, 23:20

... example, if the drive is rated for 460 VAC output and the Maximum Voltage Frequency is set to 60 Hz, the drive will maintain a constant ratio of 7 .66 V/Hz ( 460 V /60 Hz=7 .66 V/Hz). This parameter value ... output frequency * K (Pr.00.05) Example: A conveyor belt runs at 13.6m/s at motor speed 60 Hz. K = 13 .6/ 60 = 0.22 (0.2 266 67 rounded to 1 decimal), therefore Pr.00.05=0.2 With...

Ngày tải lên: 07/08/2014, 23:20

... Parameters| 4- 56 Revision June 2007, 0ELE, V1.00 01.00 analog input 04.14 04.18 04.12 04. 16 04.11 04.15 04.17 01.00 =60 .00 Hz AVI ACI analog input 04.14=70 04.18=50 04.12=30 04. 16= 0 04.11=0V 04.15=4mA 04.13=10V 04.17=20mA ... gain Pr.04.03 =0 No negative bias command Gain:100% Bias adjustment:((6Hz /60 Hz)/(Gain/100%))*100%=10.0% Negative bias 6Hz 1V 54Hz Example 6: Use of ne...

Ngày tải lên: 07/08/2014, 23:20

... example, a 1-byte data: 64 Hex, shown as 64 ’ in ASCII, consists of 6 (36Hex) and ‘4’ (34Hex). Character ‘0’ ‘1’ ‘2’ ‘3’ ‘4’ ‘5’ 6 ‘7’ ASCII code 30H 31H 32H 33H 34H 35H 36H 37H Chapter 4 Parameters| ... outportb(PORT+BRDL,12); /* set baudrate= 960 0, 12=115200/ 960 0*/ outportb(PORT+BRDH,0x00); outportb(PORT+LCR,0x 06) ; /* set protocol, <7,N,2>=06H, <7,E,1>=1AH, <7,O...

Ngày tải lên: 07/08/2014, 23:20