... Liquid Fuel Nonpeaking turbines Less than 3 MW 500 125 0 3 20 MW (1) 24 0 460 Over 20 MW 140 38 0 Peaking turbines Less than 3 MW Exempt Exempt Over 3 MW 28 0 530 Notes: (1) For the initial two-year ... in Fig. E- 12. The voltage is varied directly with the frequency. For instance, a 460-volt controller would normally be adjusted to provide 460 volts output at 60 Hz and 23 0 volt...
Ngày tải lên: 21/07/2014, 16:22
... Plot http://www.itl.nist.gov/div898 /handbook/ eda/section3/eda 333 .htm (2 of 4) [5 /1/ 2006 9:56 :32 AM] Star Plot: 1. 3. 3.29 Weibull Plot: 1. 3. 3 .30 Youden Plot: 1. 3. 3. 31 4-Plot: 1. 3. 3 .32 6-Plot: 1. 3. 3 .33 1. 3. 3. Graphical ... Plot: 1. 3. 3 . 13 Histogram: 1. 3. 3 .14 Lag Plot: 1. 3. 3 .15 Linear Correlation Plot: 1. 3. 3 .16 Linear Intercept Plot:...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 1 Part 4 ppsx
... the first and second factor (independent) variables. 1. The four vertex points are drawn. The vertex points are ( -1, -1) , ( -1, 1), (1, 1), (1, -1) . At each vertex point, the average of all the response ... and so we conclude that the X1*X2 term is not significant. 1. 3.3 .10 .1. DEX Contour Plot http://www.itl.nist.gov/div898 /handbook/ eda/section3/eda33a1.htm (3 of 4) [5 /1/ 2006 9:...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 1 Part 10 ppsx
... e Block Plot: 1. 3.3.3 Multi-Factor/Screening y = f(x1,x2,x3, ,xk) + e DEX Scatter Plot: 1. 3.3 .11 DEX Mean Plot: 1. 3.3 .12 DEX Standard Deviation Plot: 1. 3.3 .13 Contour Plot: 1. 3.3 .10 1. 3.4. Graphical ... Intercept Plot: 1. 3.3 .17 Linear Slope Plot: 1. 3.3 .18 Linear Residual Standard Deviation Plot :1. 3.3 .19 Interlab (y1,y2) = f(x) + e Youden Plot: 1. 3.3. 31 Mult...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 1 Part 11 ppsx
... 6) [5 /1/ 2006 9:57 :14 AM] FACTOR 2 1 115 24.053 711 11 524.053 711 2.8982 91. 067% FACTOR 3 1 14380.633789 14 380.633789 3. 616 6 94. 219 % FACTOR 4 1 72 714 3 .12 5000 72 714 3 .12 5000 18 2.8703 10 0.000% ... 22 13 33 18 39 22 36 19 28 18 27 23 21 26 24 25 30 20 34 21 32 13 38 14 37 15 30 14 31 17 37 11 32 13 47 12 41 13 45 15 34 13...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 5 Part 3 pptx
... 1 3 1 3 0.12 35 1 3 1 4 0.1264 1 3 1 5 0.1 239 1 3 1 6 0.1266 1 3 1 7 0.1242 1 3 1 8 0.1 231 1 3 1 9 0.1 232 1 3 1 10 0.1244 1 3 2 1 0.1 233 1 3 2 2 0.1 237 1 3 2 3 0.1244 1 3 2 4 0.1 254 ... 2 3 2 3 0.1241 2 3 2 4 0.12 15 2 3 2 5 0.1221 2 3 2 6 0.1 236 2 3 2 7 0.1229 2 3 2 8 0.12 05 2 3 2 9 0.1241 2 3 2 10 0.1 232...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 6 Part 11 ppsx
... well-behaved? http://www.itl.nist.gov/div898 /handbook/ pri/section2/pri24.htm (4 of 10) [5/1/20 06 10:30:21 AM] Interpretation of the residuals versus fitted values plots A residual distribution such as that in Figure 2 .6 showing ... not show increasing residuals 5.2.4. Are the model residuals well-behaved? http://www.itl.nist.gov/div898 /handbook/ pri/section2/pri24.htm (6 of 10) [5/1/...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 7 Part 3 potx
... Rate 1 34 97. 20 11.0 175 0.0160 X1: Table Speed* 1 4 872 . 57 15 .35 05 0.0 078 X2: Feed Rate X3: Wheel Grit 1 126 63. 96 39 .8964 0.00 07 X1: Table Speed* 1 1 838 .76 5 .79 28 0.0528 X3: Wheel Grit 5.4 .7. 1. ... 3 57. 05 1.1248 0 .32 97 X2: Feed Rate* X3: Wheel Grit X4: Direction 1 31 5 132 .65 992 .79 01 <.0001 X1: Table Speed* 1 16 37 . 21 5.1 578 0.0 636 X4: Direction X...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 9 Part 1 pot
... 7 1 .98 9234 1 2 Cen 1. 8 612 68 8 1. 845268 1 2 Rgt 2 .13 610 2 9 2 .11 810 2 1 2 Bot 1 .97 6 495 10 1 .95 6 495 1 3 Top 2.887053 11 2.865053 1 3 Lef 2.0 612 39 12 2.0372 39 1 3 Cen 1. 625 19 1 13 1. 599 19 1 1 ... 1. 690 14 7 4 1 Rgt 1 .98 0323 49 1. 882323 4 1 Bot 2 .16 2 91 9 50 2.06 2 91 9 4 2 Top 2.855 798 51 2.753 798 4 2 Lef 2 .1...
Ngày tải lên: 06/08/2014, 11:20
Engineering Statistics Handbook Episode 9 Part 3 ppsx
... 114.87611 114.87611 115.12080 114.87611 114.87611 114. 631 50 114. 631 50 114.14220 114 .38 680 114.14220 114. 631 50 114.87611 114 .38 680 114.87611 114. 631 50 114.14220 114.14220 1 13. 897 50 114.14220 1 13. 897 50 1 13. 652 89 1 13. 652 89 1 13. 40820 1 13. 40820 112 .91 890 1 13. 40820 112 .91 890 1 13. 40820 1 13. 897 50 1 13. 40820 1 13. 652 89 1 13. 897 50 1 13. 652 89 1 13. 652...
Ngày tải lên: 06/08/2014, 11:20