... 10.1.0.1 255 . 255 . 255 .0 N/A Fa0/1 10.1.1. 254 255 . 255 . 255 .0 N/A R2 S0/0/0 10.1.0.2 255 . 255 . 255 .0 N/A S0/0/1 10.3.0.1 255 . 255 . 255 .0 N/A Lo 0 10.13.2 05. 1 255 . 255 .0.0 N/A R3 S0/0/1 10.3.0.2 255 . 255 . 255 .0 ... N/A R3 S0/0/1 10.3.0.2 255 . 255 . 255 .0 N/A Fa0/1 10.3.1. 254 255 . 255 . 255 .0 N/A PC 1 NIC 10.1.1.1 255 . 255 . 255 .0 10.1.1. 254 PC 3 NIC 10.3.1.1 255 ....
Ngày tải lên: 01/08/2014, 16:20
Access Control Lists
... Copyright 2003, Cisco Systems, Inc. Case Study: Access Control Lists (ACLs) 1- 15 To help with the physical layer design the company has provided a diagram from ... connections ■ Provide detailed documentation in the appropriate format ■ Provide a written final report Copyright 2003, Cisco Systems, Inc. Case Study: Access Control Lists (ACLs) 1-13 VLAN ... up/down...
Ngày tải lên: 16/10/2013, 20:15
... lệnh “show access- list”, ta được kết quả tương tự bên dưới, trong đó có minh họa số lần chặn dữ liệu khi ping từ PC1 đến 209.1 65. 200. 255 , là interface loopback của Router R2. 5. Điều khiển ... Phiên bản tiếng Việt Trang 2/7 CCNA Lab Book version 4 VDC Training Center 4. Cấu hình Extend ACL trên R1, chặn dữ liệu từ 192.168.10.0/24 đến 209.1 65. 200. 255 , cho phép các phần còn...
Ngày tải lên: 13/05/2014, 22:22
Network Access Control For Dummies docx
... apportions access. But, access apportionment is only part of the definition of NAC because NAC encompasses so much more. 1.1.3. Control freak Control is a vital part of network access control. Controlling ... network access, or only Internet access. When deploying NAC and defining access control policies, the company usually decides how leniently or stringently they want...
Ngày tải lên: 07/03/2014, 04:20
Tài liệu Lab 5.2.1 Configuring Frame Relay doc
... started! Press Enter. Now the router is ready for the assigned lab to be performed. 5 - 5 CCNA 4: WAN Technologies v 3.0 - Lab 5. 2.1 Copyright 2003, Cisco Systems, Inc. Router Interface ... steps, finish the lab by doing the following: • Logoff by typing exit • Turn the router off • Remove and store the cables and adapter 2 - 5 CCNA 4: WAN Technologies v 3.0 - L...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 5.2.2 Configuring Frame Relay PVC doc
... 255 . 255 . 255 .0 Dublin(config-if)#frame-relay map ip 192.168.1.1 102 ietf broadcast Dublin(config-if)#bandwidth 64 Dublin(config-if)#description PVC to Washington, DLCI 102, Circuit #DASS4 658 66 ... frame-relay ietf Washington(config-if)#no keepalive Washington(config-if)#ip address 192.168.1.1 255 . 255 . 255 .0 Washington(config-if)#no shutdown Step 3 Setting up the Frame-Rela...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 5.2.3c Troubleshooting Interconnected Devices docx
... one male (DTE) V. 35 cable for interconnecting the routers Step 1 Set up the lab configuration for Team member A by doing the following: a. Set up the lab according to prior lab “Basic Routed ... network layer integrity. 2 - 3 CCNA 1: Networking Basics v 3.0 - Lab 5. 2.3c Copyright 2003, Cisco Systems, Inc. Lab 5. 2.3c Troubleshooting Interconnected Devices Objecti...
Ngày tải lên: 11/12/2013, 14:15
Shop manual máy đào HuynDai R170W-9 (Phần 5) - P5.2
... 5 3 10±3 38±3 38±3 38±3 2000 50 1900 50 1 750 50 1000±100 1000±100 850 ±100 1 950 50 1 850 50 1 850 50 - - - 1 950 50 1 850 50 1 850 50 - - - 2000 50 1900 50 1 750 50 1000±100 1000±100 850 ±100 Engine rpm Standard ... speed (rpm) Power shift (bar) 1 155 0 800 0 2 1600 850 (low idle) 3 3 1 650 900 6 4 1700 950 9 5 1 750 1000 (decel rpm) 12 6 1800 1 050 16 7 1 850 1100 20 8 190...
Ngày tải lên: 29/10/2012, 15:06