Mechanical Science HandbooksMechanical Science Handbooks 10000 Part 6 pps

... hydraulic piston and a set of mechanical flyweights, which are driven by the engine blower shaft. Figure 28 provides an illustration of a functional diagram of a mechanical- hydraulic governor. ... fuel. Figure 28 Simplified Mechanical- Hydraulic Governor Rev. 0 ME-01 Page 35 Diesel Engine Fundamentals DOE-HDBK-1018/1-93 DIESEL ENGINE SPEED, FUEL CONTROLS, AND PROTECTION Figure 26 Fuel I...

Ngày tải lên: 21/07/2014, 17:20

... Trap 36 Thermostatic Steam Traps 36 Bellows-Type Steam Trap 36 Impulse Steam Trap 37 Orifice-Type Steam Trap 38 Summary 39 ME-05 Page ii Rev. 0 Department of Energy Fundamentals Handbook MECHANICAL ... 1 Introduction 1 Reciprocating Compressors 1 Rotary Compressors 4 Centrifugal Compressors 6 Compressor Coolers 6 Hazards of Compressed Air 7 Summary 8 HYDRAULICS 10 Introduction 10 Pre...

Ngày tải lên: 21/07/2014, 17:20

Ngày tải lên: 21/07/2014, 17:20

... follower and pushrod. Fuel injection continues until 6 BTDC (17 total degrees of injection), as illustrated in Figure 24. ME-01 Rev. 0 Page 26 DOE-HDBK-1018/1-93 FUNDAMENTALS OF THE DIESEL CYCLE ... compression. In an actual engine, pressures reach only about 69 0 psia. This is due primarily to the heat loss to the surrounding engine parts. Fuel Injection Figure 18 Fuel Injection Fuel in...

Ngày tải lên: 21/07/2014, 17:20

... and Control; Electrical Science; Material Science; Mechanical Science; Chemistry; Engineering Symbology, Prints, and Drawings; and Nuclear Physics and Reactor Theory. The handbooks are provided ... not all-encompassing. An attempt to present the entire subject of mechanical science would be impractical. However, the Mechanical Science handbook presents enough information to pr...

Ngày tải lên: 21/07/2014, 17:20

... 4/9 4/9 Þ O / O . O . O . O . O 0 O 0 O 0 O 1 O 1 O 1 O 1 O 2 O 2 O 2 O 2 O 3 O 3 O 3 O 3 Þ O 4 O 4 O 4 O 5 O 5 O 5 O 5 O 6 O 6 O 6 O 6 O 7 O 7 O 7 O 7 O 8 O 8 O 8 O 8 O 9 O 9 Þ O 9 Write answer → in boxes. ← Fraction line ⎧ ⎪ ⎨ ⎪ ⎩ Grid ... of the National Woman’s Suffrage Association? (D) What are “partial suffrages?” (E) Which constitutional amendment gave women the vote? 16. The...

Ngày tải lên: 22/07/2014, 10:22

... 19 POSITIVE DISPLACEMENT PUMPS DOE-HDBK-1018/1-93 Pumps Lobe Type Pump Figure 16 Lobe Type Pump The lobe type pump shown in Figure 16 is another variation of the simple gear pump. It is considered as a ... self- priming features, it is essential that all clearances between rotating parts, and between rotating and stationary parts, be kept to a minimum in order to reduce slippage. Slippage...

Ngày tải lên: 21/07/2014, 17:20

... DOE-HDBK-1018/1-93 Pumps Mechanical Seals In some situations, packing material is not adequate for sealing the shaft. One common alternative method for sealing the shaft is with mechanical seals. Mechanical ... in design and construction from simple pumps with relatively few parts to extremely complicated pumps with hundreds of individual parts. Some of the most common components found...

Ngày tải lên: 21/07/2014, 17:20

... vanes of the rotating impeller impart a radial and rotary motion to the liquid, forcing it to the outer periphery of the pump casing where it is collected in the outer part of the pump casing called ... most common type of pumps found in DOE facilities. Centrifugal pumps enjoy widespread application partly due to their ability to operate over a wide range of flow rates and pump heads. EO 1....

Ngày tải lên: 21/07/2014, 17:20

... 27 Positive Displacement Pump Protection 28 Summary 28 Rev. 0 ME-03 Page i Department of Energy Fundamentals Handbook MECHANICAL SCIENCE Module 3 Pumps Heat Exchangers DOE-HDBK-1018/1-93 HEAT EXCHANGER ... Centrifugal Pumps 15 Summary 16 POSITIVE DISPLACEMENT PUMPS 18 Introduction 18 Principle of Operation 19 Reciprocating Pumps 19 Rotary Pumps 22 Diaphragm Pumps 26 Positive Displaceme...

Ngày tải lên: 21/07/2014, 17:20