Designation: C 588/C 588M – 99 - Gypsum Base for Veneer Plasters1 docx

... in accordance with specification C 1264 /C 1264M. 6.2 Thickness, width, length, and end squareness shall be determined in accordance with Test Methods C 473. 6.2.1 Thickness—The nominal thickness ... Appearance 7.1 The surface of gypsum base for veneer plaster shall be free of any imperfections or foreign substances that render it unfit for the intended use. 8. Sampling, Inspecti...

Ngày tải lên: 10/07/2014, 23:20

... Designation: C 588 /C 588M – 99 Standard Specification for Gypsum Base for Veneer Plasters 1 This standard is issued under the fixed designation C 588 /C 588M; the number immediately ... Systems 2 C 473 Test Methods for Physical Testing of Gypsum Panel Products 2 C 645 Specification for Nonstructural Steel Framing Mem- bers 2 C 1264 /C 1264M Specification...

Ngày tải lên: 10/07/2014, 23:20

... Testing of Hydraulic Cements and Concretes 2 C 1005 Specification for Reference Masses and Devices for Determining Mass and Volume for Use in the Physical Testing of Hydraulic Cements 2 3. Terminology 3.1 ... for checking the FIG. 1 Molds (SI Units) C 490 2 Designation: C 490 – 00a Standard Practice for Use of Apparatus for the Determination of Length Change of Hardened...

Ngày tải lên: 10/07/2014, 23:20

... Build- ing Materials and Systems 2 C 36 Specification for Gypsum Wallboard 2 C 472 Test Methods for Physical Testing of Gypsum, Gyp- sum Plasters, and Gypsum Concrete 2 C 475 Specification for Joint ... Steel-Reinforced Broad Knife, in accordance with 6.4.6. 13.4.3 Gypsum Wallboard, Specification C 36 8 , two pieces, 6 by 14 in. (150 by 350 mm) with the 14-in. (350-mm) lengt...

Ngày tải lên: 10/07/2014, 23:20

... Sampling, Inspection, etc. 7.1 The sampling, inspection, rejection, retesting, packing, and marking shall be conducted in accordance with Methods C 50. 8. Test Methods 8.1 Conformance to chemical requirements ... deter- mined in accordance with Test Methods C 25. 8.2 Conformance to plasticity and residue requirements shall be determined in accordance with Test Methods C 110. 9. Keywords...

Ngày tải lên: 10/07/2014, 23:20

... Lime 2 C 109 Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or 50-mm Cube Specimens) 2 C 150 Specification for Portland Cement 2 C 151 Test Method for Autoclave Expansion ... Portland Cement 2 C 184 Test Method for Fineness of Hydraulic Cement by the 15 0- m (No. 100) and 7 5- µm (No. 200) Sieves 2 C 187 Test Method for Normal Consistency...

Ngày tải lên: 10/07/2014, 23:20

... specifica- tion in accordance with the methods prescribed in Sections 7-1 1. 7. Tests on Cement 7.1 Test the cement samples in accordance with the follow- ing methods: 7.1.1 Chemical Analysis of Cement—Test ... be calculated the potential percentages of the following compounds: tricalcium silicate, dicalcium silicate, tricalcium aluminate, and tetracalcium alu- minoferrite. Determinations...

Ngày tải lên: 10/07/2014, 23:20

... at the time of shipment certifying that the product is in compliance with this speci - cation. 1 This specification is under the jurisdiction of ASTM Committee C- 11 on Gypsum and Related Building ... Methods C 474. 4.2 Joint Compounds. 4.2.1 Check Cracking—No cracks in the thinner half of the wedge and no deep fissure cracks in the thicker half of the wedge. 4.2.2 Putrefaction—No putre...

Ngày tải lên: 10/07/2014, 23:20

... Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or 50-mm Cube Specimens) 2 C 114 Test Methods for Chemical Analysis of Hydraulic Cement 2 C 150 Specification for Portland Cement 2 C ... 1—This specification prescribes ingredients and proportions, with some performance requirements whereas Performance Specification C 1157 is a blended cement specification in...

Ngày tải lên: 10/07/2014, 23:20

... Lime 2 C 125 Terminology Relating to Concrete and Concrete Aggregates 3 D 3176 Practice for Ultimate Analysis of Coal and Coke 4 E 11 Specification for Wire-Cloth Sieves for Testing Pur- poses 5 3. ... slag—air-cooled blast-furnace slag and granulated blast furnace slag as defined in Terminology C 125. 3.1.3 calcium carbonate equivalent (C. C.E.)—the acid- neutralizing capacity (of an...

Ngày tải lên: 10/07/2014, 23:20