testking''s building cisco remote access networks version 9 0

... protocol is used, that port is 200 0 plus the line number, for example: telnet 10. 10. 30. 4 20 09 This command initiates a Telnet connection to line 9 ( 200 0 + 9) . The following line types ... enterprise networks to connect regional and branch offices into the enterprise backbone. Reference: http://www .cisco. com/en/US/products/hw/modules/ps 203 3/products_white_paper...

Ngày tải lên: 06/07/2014, 01:26

... 255.255.255 .0 encapsulation ppp dialer idle-timeout 30 dialer load-threshold 40 either dialer map ip 10. 12.15.8 name RTB 8 10 199 9888 8 90 1 dialer map ip 10. 12.15 .9 name RTC 8 10 199 98881234 dialer ... time interval, what will be the value of the committed burst (Bc) A. 3 200 0 bits B. 2 400 0 bits C. 1 600 0 bits D. 800 0 bits 642 - 821 Leading the way in IT...

Ngày tải lên: 10/12/2013, 17:15

... high_ip_pool_address 6 40- 605 Remote Access 3 .0 www.testking.com - 1 - 6 40- 605 Study Guide Remote Access 3 .0 (Building Cisco Remote Access Networks) Version 1 6 40- 605 Remote Access 3 .0 www.testking.com ... Telnet (binary mode) 600 0–6xxx 700 0–7xxx Xremote 90 00 –9xxx 100 00 10xxx TABLE 3.3: Standard AT Commands Command Result A...

Ngày tải lên: 10/12/2013, 17:15

... ip_address . 6 40- 605 Remote Access 3 .0 www.testking.com - 1 - 6 40- 605 Study Guide Remote Access 3 .0 (Building Cisco Remote Access Networks) Version 1 6 40- 605 Remote Access 3 .0 www.testking.com ... Telnet (binary mode) 600 0–6xxx 700 0–7xxx Xremote 90 00 –9xxx 100 00 10xxx TABLE 3.3: Standard AT Commands Command Result AT&F...

Ngày tải lên: 18/10/2013, 18:15

... http://www .cisco. com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter 09 1 86a 008 00 7ff07.html# 100 09 4 6 QUESTION NO: 51 What is the maximum time that a voice package should be allowed to cross a network? A. 90 milliseconds B. 1 20 milliseconds C. 1 50 ... http://www .cisco. com/en/US/tech/tk828/tk363/technologies_white_paper 09 1 86a 008 0 09 2...

Ngày tải lên: 26/10/2013, 23:15

... Wiring Type Pairs Cable Length 100 BaseTX EIA/TIA Category 5 UTP 2 100 m 100 BaseT2 EIA/TIA Category 3,4,5 UTP 2 100 m 100 BaseT4 EIA/TIA Category 3,4,5 UTP 4 100 m 100 BaseFX Multimode fiber (MMF) ... (MMF) with 62.5 micron core; 1 300 nm laser 1 400 m (half-duplex) 2 ,00 0 m (full-duplex) Single-mode fiber (SMF) with 62.5 micron core; 1 300 nm laser 1 10, 000 m 2.1.3 Giga...

Ngày tải lên: 10/12/2013, 17:15

Ngày tải lên: 11/12/2013, 03:15

... QUESTION NO: 64 What is the device weight limit per CallManager in a Cisco IP phone configuration? A. 2 500 B. 300 0 C. 500 0 D. 6 500 Answer: C QUESTION NO: 65 Which of the following ... consisting of three buildings that are 1 50 feet apart. The buildings are connected with single-mode fiber using fast Ethernet. Access to the network is provided by 10 Mbps hubs...

Ngày tải lên: 10/12/2013, 16:15

... terminal or modem and the console port. On the Catalyst 1 90 0, 28 20, 2 90 0, 3 500 , 292 6G, 294 8G, 491 2G, 500 0 Supervisor IIG/III/IIIG, and the 600 0 switches, the rollover cable plugs directly into the ... • The 1 90 0/ 2 800 Series, which provides switched 10 Mbps to the desktop or to 10BaseT hubs in small to medium campus networks. • The 2 90 0 Series, which provides 10/...

Ngày tải lên: 16/10/2013, 13:15