Using NAT and PAT statements on the cisco secure PIX firewall

... Port Redirection(Forwarding) on PIX 5.x and later. Prerequisites Requirements Cisco recommends that you have knowledge of the Cisco Secure PIX Firewall. Cisco − Using NAT and PAT Statements on the Cisco Secure ... web and 172.16.1.4 is used for Telnet, and must convert all of the internal addresses, which Cisco − Using NAT and PAT Statemen...

Ngày tải lên: 05/07/2014, 23:50

... configuring the PIX Firewall for failover, you must configure the primary and secondary PIX Firewalls exactly the same. B. Configuration can be modified on either the primary or secondary PIX ... commands, and configuration mode commands all work in configuration mode. B. Only configuration mode commands work in configuration mode. C. Unprivileged mode commands and...

Ngày tải lên: 18/10/2013, 18:15

... addresses on the primary PIX Firewall if it fails? A. They become those of the standby PIX Firewall. B. The ones on the primary PIX Firewall remain the same, but the current IP addresses of the ... host on the more secure interface of the PIX Firewall, the PIX Firewall creates an entry in its session state table. The PIX Firewall is abl...

Ngày tải lên: 22/10/2013, 16:15

... happen to the current IP addresses on the primary PIX Firewall if it fails? A. They become those of the standby PIX Firewall. B. The ones on the primary PIX Firewall remain the same, but the current ... C. The active PIX Firewall is waiting for configuration replication to be completed. D. The primary PIX Firewall has finished testing the standby...

Ngày tải lên: 17/01/2014, 14:20

... the standby PIX Firewall. B. The ones on the primary PIX Firewall remain the same, but the current IP addresses of the secondary become the virtual IP addresses you configured. C. They are deleted. ... QUESTION NO: 45 In the output of the show failover command, what does cable status waiting mean? A. The active PIX Firewall is working and the standb...

Ngày tải lên: 24/01/2014, 10:20

... in the translation table for the PIX Firewall Answer: Clear xlate QUESTION NO: 19 Which portion of the conduit command denies access through the PIX Firewall in the conditions ... function of the PIX Firewall that provides a safeguard in case a PIX Firewall fails. Answer: Failover QUESTION NO: 4 What does the nat command allow you t...

Ngày tải lên: 24/01/2014, 10:20

... Networks (VPNs) 30 Cisco Secure PIX 501 30 Cisco Secure PIX 506 31 Cisco Secure PIX 515 33 Cisco Secure PIX 520 35 Cisco Secure PIX 525 38 Cisco Secure PIX 535 39 Foundation Summary 42 Q&A ... Technologies and the Cisco PIX Firewall 13 Chapter 3 The Cisco Secure PIX Firewall 23 Chapter 4 System Maintenance 47 Chapter 5 Und...

Ngày tải lên: 25/03/2014, 11:08

... this lesson, you will be able to: • Describe the features and operation of NAT on Cisco routers • Use Cisco IOS commands to configure NAT, given a functioning router • Use show commands to identify ... anomalies in the NAT configuration, given an operational router • Use debug commands to identify events and anomalies in the NAT configuration, given an operational...

Ngày tải lên: 06/03/2014, 15:20

... radiation and natural convection are limited. Thus, heat transfer between the hot saline water bed and the condensation surface in every stage is mainly conveyed by evaporation and condensation ... performance. The heat lost to the surroundings from the absorber plate through the glass cover by conduction, convection and radiation is calculated using energy balance eq...

Ngày tải lên: 05/09/2013, 16:11

... international relations o Interdependence amongst national economies has increased o In international relations, there have always existed two dimensions: cooperation and competition. 1.2Education 1.2.1 ... (UNESCO, 2003) in the national context, and foreign education in the international context: • Schooling. This includes primary and secondary education: primary or elementary...

Ngày tải lên: 23/04/2013, 11:16