Giáo Trình CIs+ part 30 pdf

Giáo Trình CIs+ part 52 pdf

Giáo Trình CIs+ part 52 pdf

... Packets switched: 62 430 Hardware switched outgoing interfaces: Vlan20 Vlan9 MFD installed: Vlan11 (1.1.11.3, 224.1.1.1) Incoming interface: Vlan11, Packets switched: 62 430 Hardware switched ... router: Router# show mls ip multicast summary 7 MMLS entries using 560 bytes of memory Number of partial hardware-switched flows:2 Number of complete hardware-switched flows:5 Router# · C...

Ngày tải lên: 05/07/2014, 10:20

6 140 0
Giáo Trình CIs+ part 73 pdf

Giáo Trình CIs+ part 73 pdf

... Echos to 203 .30. 30.2, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 64/64/64 ms R3# *Mar 1 00:47:59.363: NAT: s=10.10.1.1->203.162.3.1, d=203 .30. 30.2 [34] ... 26 00 00 FF 01 03 AF CB A2 03 01 CB 1E 1E 02 08 00 61 E3 0F *Mar 1 00:47:59.679: NAT*: s=203 .30. 30.2, d=203.162.3.1->10.10.1.1 [38] *Mar 1 00:47:59.683: PPPoE 1: I L:0005.5e96.2cc0 R...

Ngày tải lên: 05/07/2014, 10:20

5 199 0
Giáo Trình CIs+ part 75 pdf

Giáo Trình CIs+ part 75 pdf

... subnetted, 2 subnets, 2 masks i L1 172.16.1.0/24 [115/20] via 192.168.2.2, Serial0/0 O 172.16.2.0 /30 [110/138] via 192.168.1.1, 00:01:51, Serial0/1 O 192.168.4.0/24 [110/74] via 192.168.1.1, 00:01:51, ... [115/20] via 192.168.2.2, Serial0/0 C 192.168.1.0/24 is directly connected, Serial0/1 192.168.2.0 /30 is subnetted, 1 subnets C 192.168.2.0 is directly connected, Serial0/0 R5#show...

Ngày tải lên: 05/07/2014, 10:20

5 259 0
Giáo Trình CIs+ part 85 pdf

Giáo Trình CIs+ part 85 pdf

... Serial2 302 interface Serial2 no ip address no keepalive encapsulation frame-relay clockrate 64000 frame-relay intf-type dce frame-relay route 301 interface Serial0 103 frame-relay route 302 ... mapped to S1 frame-relay route 102 interface Serial1 201 frame-relay route 103 interface Serial2 301 interface Serial1 no ip address no keepalive encapsulation frame-relay clockrate...

Ngày tải lên: 05/07/2014, 10:20

6 176 0
Giáo Trình CIs+ part 89 pdf

Giáo Trình CIs+ part 89 pdf

... value that is between 50% and 30% of the SYN flood rate burst normal and burst max rates with accurate values Note that if you set the burst rate greater than 30% , many legitimate SYNs may ... Review the numbers carefully before deploying this measure. If an SYN attack is aimed against a particular host, consider installing an IP filtering package on that host. One such package is

Ngày tải lên: 05/07/2014, 10:20

6 174 0
Giáo Trình CIs+ part 97 pdf

Giáo Trình CIs+ part 97 pdf

... supernet route và sẻ loại bỏ(suppress) các route cụ thẻ hơn . Ví dụ: RTA(config)#router bgp 300 RTA(config-router)#neighbor 3.3.3.3 remote-as 200 RTA(config-router)#neighbor 2.2.2.2 remote-as ... kết nối T3 theo đường của YNET. LA có thể gán route đến từ YNET một giá trị Local Prefernece 300 , và San Jose gán cho route đến từ YNET một giá trị thấp hơn là 200. Bởi vì cả hai router...

Ngày tải lên: 05/07/2014, 10:20

6 168 0
w