... how the processing of the IPv6 topology went. You can see the log for the IPv6 MT Topology using the show isis ipv6 spf-log command. IOS command output The show isis ipv6 spf-log command shows the ... MPLS as well. The label will be written into the VPI/VCI fields and the forwarding paradigm stays the same. The label look up determines the outgoing port and outgoing l...
Ngày tải lên: 02/07/2014, 20:21
... — [… ] The last step is to verify if the route in question has been inserted in the IP routing table. The output of the show ip route command shows if the IS-IS supplied route is the best in the ... output The show ip route command displays all the contents of the IPv4 Unicast Routing Table. Alternatively, you can append the isis qualifier to the commands, which...
Ngày tải lên: 02/07/2014, 20:21
Tài liệu The Complete Aquarium Guide - Part 2 pdf
... are attached to the roof of the spawning site; the female tends them while the male defends the territory. The fry are free-swimming after 8-10 days, under the watchful eyes of the adults. J. ... which can be mated with the normal variety; the fry will then display the coloration of one or other of the parents. Size: 10-15 cm. Labeo bicolor The red-tailed black shark...
Ngày tải lên: 26/01/2014, 18:20
Tài liệu HTML & CSS: The Complete Reference- P16 pdf
... facility to analyze the font usage on the page. The program should create an .eot file that contains the embedded fonts. Then, add the font usage information to the page in the form of Cascading ... the font supported. For example, notice the obvious variation in the rendering of the previous example across the four most popular browsers. Depending on the font in...
Ngày tải lên: 26/01/2014, 09:20
The Complete IS-IS Routing Protocol potx
... a good start for the self-education of both the novice and the seasoned network engineer in the IS-IS routing protocol. The consistent approach is to explain the theory and then show how things ... an IP header. The packet then leaves the End System and is either sent directly to the receiving end system (if it is on the same network) or passed to the default router....
Ngày tải lên: 27/06/2014, 00:20