The Complete IS-IS Routing Protocol- P1 pps
The Complete IS-IS Routing Protocol- P1 pps
... link, then the routers start to discover each other in their network. Next, IP routing information is exchanged. The remote network information is entered in the local routing table of the route ... connection-oriented architectures). The whole transmission path is pre-computed by the source. The ATM forwarding paradigm thereby follows a source routing model. The IP rou...
Ngày tải lên: 02/07/2014, 20:21
The Complete IS-IS Routing Protocol- P6 ppsx
... number by one, and send the LSP to all of its neighbours. The neighbours compare the incoming LSP with the LSP in the local database. If the received LSP is new to them (that is, the LSPs and Revision ... defects. The LSP-ID field determines the LSP type. Figure 6.7 shows the structure of the LSP- ID field. The LSP-ID is a fixed 8-byte field. The first 6 bytes are set to...
Ngày tải lên: 02/07/2014, 20:21
The Complete IS-IS Routing Protocol- P12 pps
... Vienna If there is no hostname in the hostname cache, then most likely the router in question does not originate the Hostname TLV as part of its link-state PDU. Dynamic Hostnames 349 TABLE 13.1. The IS-IS ... common in the service provider community and significantly help to con- trol the re-rerouting behaviour even in large IS-IS networks. The following IOS configuration snip...
Ngày tải lên: 02/07/2014, 20:21
The Complete IS-IS Routing Protocol- P16 pps
... — [… ] The last step is to verify if the route in question has been inserted in the IP routing table. The output of the show ip route command shows if the IS-IS supplied route is the best in the ... output The show ip route command displays all the contents of the IPv4 Unicast Routing Table. Alternatively, you can append the isis qualifier to the commands, which...
Ngày tải lên: 02/07/2014, 20:21
