... Monograph 106, May, 1968.
3.
Kent's Mechanical Engineer's Handbook, 1950 edition,
pp.
4-50
to
4-60.
4.
Huntington
Alloys, Inc., Alloy Handbook,
and
Bulletins.
5.
Inco
internal ... plate
thickness
in
order
to
maintain
a
brilliant,
tarnish-free, hard exterior surface.
Mechanical
Engineers'
Handbook,
2nd
ed., Edited
by
Myer Kutz.
ISBN
0-471-13007-9...
... high mechanical
properties.
Die
casting
is a
process
for the
production
of
castings with good dimensional tolerances,
good
surface,
and
acceptable properties
at
quite
low
cost.
Mechanical ... are
given
in
Table 7.2.
7.3.2 Mechanical Properties
of
Wrought Products
Wrought
products
are
produced
as
forgings, extrusions, sheet,
and
plate. Mechanical properties...
... the
Revised
from
Chapter
8,
Kent's Mechanical Engineer's Handbook, 12th ed.,
by
John
M.
Lessells
and
G. S.
Cherniak.
Mechanical
Engineers' Handbook,
2nd
ed.,
Edited
by
Myer ... for the
determination
of the
principal
stresses. (Reproduced
by
permission from
J.
Marin, Mechanical Properties
of
Materials
and
Design,
McGraw-Hill,
New
York, 1942.)...
... little
or no
correlation between
the
creep properties
of
a
material
and its
room-temperature
mechanical
properties.
Therefore, test data
and
empirical methods
of
extending these data
... extrapolating short-time
creep data
to
long-term applications
are the
abridged method,
the
mechanical acceleration method,
and
the
thermal acceleration method.
In the
abridged meth...
... (eds.), Mechanical Engineering Publications, Bury
St.
Edmunds,
Suffolk,
1979,
pp.
22-27.
45. A. B.
Jones, "The Mathematical Theory
of
Rolling Element
Bearings,"
in
Mechanical ... Polytechnica,
Mechanical
Engineering Series, Vol.
I, No. 3,
1947.
49. G.
Lundberg
and A.
Palmgren, "Dynamic Capacity
of
Rolling
Bearings,"
Acta Polytechnica,
Mechanical...