0
  1. Trang chủ >
  2. Công Nghệ Thông Tin >
  3. Kỹ thuật lập trình >

Signaling System No 7 Protocol Architecture And Sevices part 67 pps

Signaling System No.7 Protocol Architecture And Sevices part 67 pps

Signaling System No.7 Protocol Architecture And Sevices part 67 pps

... subsystem, to the backup of the subsystem that is now allowed. Allows the end node to update the traffic mix information that the subsystem is receiving. SRT (A) 1 1 1 1 1 1 1 1 Subsystem ... therefore, only used in protocol class 3. EA (NE) 0 0 0 0 1 1 0 0 Expedited Data Acknowledgment Used to acknowledge an ED message. Each ED message must be acknowledged before another is sent. ... destinations that a formerly prohibited subsystem (such as VLR/HLR) is now available, or that a previously unavailable SCCP is now available. As a result, the node receiving the SSA updates its...
  • 6
  • 139
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 3 pps

Signaling System No.7 Protocol Architecture And Sevices part 3 pps

... therefore, signaling is sent above the 3400 Hz (and below 4000 Hz). This is known as out-of-band signaling and is used in R2 for supervisory signaling. Unlike with in-band signaling, no contention ... implemented using the following related systems: • Bell Systems MF, R2, R1, and C5. • Single-frequency (SF) in-band and out-of-band signaling • Robbed bit signaling The following sections discuss ... frequency bandwidth, only signaling or user traffic can be present at any one time. Therefore, in-band signaling is restricted to setting up and clearing calls down only because signaling is not possible...
  • 7
  • 305
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 16 pps

Signaling System No.7 Protocol Architecture And Sevices part 16 pps

... congestion was recognized. This acknowledgment delay would normally cause timer T7, excessive delay of acknowledgment, at the distant SP to time out; however, timer T7 restarts each time an SIB is ... it notifies its MTP3 and begins to continuously transmit FISUs. Note that the affected links remain in the aligned state. < Day Day Up > < Day Day Up > between 6 and 279 ... threshold values Tin and Tie are used for the normal and emergency alignment procedures, respectively. If the proving is aborted M times, the link is removed from service and enters the idle...
  • 12
  • 220
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 19 ppsx

Signaling System No.7 Protocol Architecture And Sevices part 19 ppsx

... Allocation of Signaling Terminals and Links The SS7 standards provide specifications for the automatic allocation of both signaling terminals and signaling links. The automatic allocation of signaling ... recovering from SS7 outages. The newly in-service or recovering node deals with heavy SS7 management traffic and might have limited SS7 resources available initially. The Table 7- 5. H0 and H1 Field ... traffic patterns and flow accordingly. Link management activates, deactivates, and restores signaling links. This involves notifying MTP users of the availability of signaling links and invoking...
  • 25
  • 252
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 21 pps

Signaling System No.7 Protocol Architecture And Sevices part 21 pps

... call signaling from CAS to Common Channel Signaling (CCS) is that the signaling and voice are now traveling on two separate paths through the network. Before the introduction of SS7 signaling, ... identify the two parties who are involved in a telephone conversation. For example, the originating party is also known as the calling party, or the "A" party. The terminating party, or ... the figure: • T7 awaiting address complete timer— Also known as the network protection timer. T7 is started when an IAM is sent, and is canceled when an ACM is received. If T7 expires, the...
  • 10
  • 210
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 23 ppsx

Signaling System No.7 Protocol Architecture And Sevices part 23 ppsx

... called party exist in many countries; however, terminal portability for the calling party is not supported as often. ANSI networks do not support terminal portability for the calling party. ... group. The provisioned signaling type for the selected trunk group determines whether ISUP signaling or some other signaling, such as Multifrequency (MF), is used. When the signaling type is determined ... associated with the ported number and uses the new number to route the call. Using the QOR and RTP mechanisms, an IAM is sent and an REL received back from the donor network, therefore, requiring...
  • 8
  • 257
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 26 ppsx

Signaling System No.7 Protocol Architecture And Sevices part 26 ppsx

... Application Part (CAP), MAP, INAP, and AIN. Table 9-1 shows the connectionless service protocol classes and features. Table 9-1. Connectionless Service Protocol Classes Protocol Class and Name ... Control Part (SCCP) is defined in ITU-T Recommendations Q .71 1-Q .71 6 [58–63] and for North American markets in ANSI T1.112 [2]. SCCP sits on top of Message Transfer Part 3 (MTP3) in the SS7 protocol ... connection-oriented service protocol classes and features. Table 9-2. Connection-oriented Service Protocol Classes Protocol Class and Name Features Example Use Protocol Class 2: Basic Connection-oriented...
  • 11
  • 229
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 45 ppsx

Signaling System No.7 Protocol Architecture And Sevices part 45 ppsx

... Interfaces and Protocols The previous section introduced GSM network architecture, and this section introduces the SS7/C7 protocols that are used. It also discusses interfaces, because different protocols ... interfaces. The SS7/C7 protocols MTP, SCCP, TUP, ISUP are protocols that were used before digital wireless networks were available. The final part of this section introduces SS7/C7 protocols that ... the call, and the MAP/C protocol The air interface (MS-BTS) and the Abis interface (BTS-BSC) do not have a network layer. All other interfaces in the GSM system use SS7/C7s MTP3 and SCCP at...
  • 6
  • 263
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 55 ppsx

Signaling System No.7 Protocol Architecture And Sevices part 55 ppsx

... alternative to H.323. SIP is a signaling protocol that handles the setup, modification and teardown of multimedia sessions. It was developed in the IETF as a signaling protocol for establishing ... Reliable UDP (RUDP) and Session Manager (SM) protocols. A generic backhaul protocol layer is used to provide adaptation between MTP Level 2 and MTP Level 3. Figure 14-28 shows the protocol stacks ... used by the SLT and PGW2200. Figure 14-28. Cisco SLT Protocol Stack RUDP is a simple packet-based transport protocol that is based on Reliable Data Protocol (RFC 1151 [148] and RFC 908 [149])....
  • 6
  • 248
  • 0
Signaling System No.7 Protocol Architecture And Sevices part 57 pps

Signaling System No.7 Protocol Architecture And Sevices part 57 pps

... reporting asynchronous status changes to layer management M2PA can be used between a SG and a MGC, between a SG and an IPSP, and between two IPSPs. In any scenario, both sides of the M2PA protocol must ... sides of the M2PA protocol must be assigned an SS7 point code. Two IPSPs can use M2PA IP links and standard SS7 links simultaneously to send and receive MTP Level 3 messages. Figure 14-21 ... Up Acknowledge 4 ASP Down Acknowledge 5 Heartbeat Acknowledge 6 4 ASP Traffic Maintenance (ASPTM) messages ASP Active 1 ASP Inactive 2 ASP Active Acknowledge 3 ASP Inactive Acknowledge...
  • 9
  • 244
  • 0

Xem thêm

Từ khóa: how to install dual operating system windows 7 and xphow to install dual operating system windows 7 and 8how to install dual operating system windows 7 and ubuntuarchitecture and the identicalstep 7 in lad and fbdvsx architecture and conceptsBáo cáo thực tập tại nhà thuốc tại Thành phố Hồ Chí Minh năm 2018Nghiên cứu sự hình thành lớp bảo vệ và khả năng chống ăn mòn của thép bền thời tiết trong điều kiện khí hậu nhiệt đới việt namNghiên cứu vật liệu biến hóa (metamaterials) hấp thụ sóng điện tử ở vùng tần số THzGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitGiáo án Sinh học 11 bài 13: Thực hành phát hiện diệp lục và carôtenôitNGHIÊN CỨU CÔNG NGHỆ KẾT NỐI VÔ TUYẾN CỰ LY XA, CÔNG SUẤT THẤP LPWAN SLIDETrả hồ sơ điều tra bổ sung đối với các tội xâm phạm sở hữu có tính chất chiếm đoạt theo pháp luật Tố tụng hình sự Việt Nam từ thực tiễn thành phố Hồ Chí Minh (Luận văn thạc sĩ)Phát hiện xâm nhập dựa trên thuật toán k meansNghiên cứu, xây dựng phần mềm smartscan và ứng dụng trong bảo vệ mạng máy tính chuyên dùngNghiên cứu khả năng đo năng lượng điện bằng hệ thu thập dữ liệu 16 kênh DEWE 5000Chuong 2 nhận dạng rui roKiểm sát việc giải quyết tố giác, tin báo về tội phạm và kiến nghị khởi tố theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn tỉnh Bình Định (Luận văn thạc sĩ)Tăng trưởng tín dụng hộ sản xuất nông nghiệp tại Ngân hàng Nông nghiệp và Phát triển nông thôn Việt Nam chi nhánh tỉnh Bắc Giang (Luận văn thạc sĩ)Tranh tụng tại phiên tòa hình sự sơ thẩm theo pháp luật tố tụng hình sự Việt Nam từ thực tiễn xét xử của các Tòa án quân sự Quân khu (Luận văn thạc sĩ)Nguyên tắc phân hóa trách nhiệm hình sự đối với người dưới 18 tuổi phạm tội trong pháp luật hình sự Việt Nam (Luận văn thạc sĩ)Giáo án Sinh học 11 bài 14: Thực hành phát hiện hô hấp ở thực vậtChiến lược marketing tại ngân hàng Agribank chi nhánh Sài Gòn từ 2013-2015HIỆU QUẢ CỦA MÔ HÌNH XỬ LÝ BÙN HOẠT TÍNH BẰNG KIỀMMÔN TRUYỀN THÔNG MARKETING TÍCH HỢPQUẢN LÝ VÀ TÁI CHẾ NHỰA Ở HOA KỲ