Lifetime-Oriented Structural Design Concepts- P3 pps

... T. Bruhns · Dietrich Hartmann Rüdiger Höffer · Detlef Kuhl Günther Meschke (Eds.) Lifetime-Oriented Structural Design Concepts ABC XVI Contents 3.3.4.2.10 Finite ElementCalculations of the (Reduced)Static ... representing the fields of structural engineering, structural mechanics, soil mechanics, material sci- ence, and numerical mathematics introduced a research program on “lifetime...

Ngày tải lên: 01/07/2014, 10:43

... research Integrated design concepts Appropriate Quality Assurance for structural design, detailing and execution QA is a very important overhead necessity, also for lifetime-oriented design concepts, ... Fundamentals of Lifetime-Oriented Design 7 lifetimes. The progress in lifetime-oriented design concepts can contribute to an international harmonization of warranty law. 1.5...

Ngày tải lên: 01/07/2014, 10:43

... considered for realistic lifetime oriented design concepts especially with regard to the fatigue damage of structures and structural members. The basis of such design concepts is the realistic modelling ... Bridges Authored by Gerhard Hanswille For a realistic lifetime oriented design especially with regard to the fatigue damage of structures and structural members realistic models...

Ngày tải lên: 01/07/2014, 10:43

... numbers N T o of lorries during the design life assumed for λ 2 = 1.0. Therefore the factor differs for structures and structural members with different materials (e.g. structural steel, reinforcement, ... traffic category 2 in Table 3.14. Furthermore for the design life a reference value T so = 100 years was assumed. In case of another traffic category or design life the damage equivalen...

Ngày tải lên: 01/07/2014, 10:43

... the design as long as the train speed is sufficiently below the critical. If however the critical speed is lower than the maximal track speed, resonant amplification will provide the dominant design ... Pattern for Static and Dynamic Design Calculations The following expression summarizes the observed effects and may be applied to static and in particular to dynamic design calculations: q...

Ngày tải lên: 01/07/2014, 10:43

... shallow foundations side by side) and different loadings arising from the superstructure design (despite design efforts to avoid this). 108 2 Damage-Oriented Actions and Environmental Impact Fig. ... yield strength undergo progressive, localized, and permanent structural changes, i.e. also in these materials fatigue takes place. The structural change thus can be described on the macrosc...

Ngày tải lên: 01/07/2014, 10:43

... loading (Subsections 3.2.1.2 and (Subsections 3.2.2) and structural experiments of steel-concrete composite structures (Subsection 3.2.3). 3.2.1 Laboratory Testing of Structural Materials Authored by Otto T. ... envi- ronmentally induced degradation mechanisms, which led to a better under- standing of the microstructural mechanisms and to analysis tools to simulate the relevant processes....

Ngày tải lên: 01/07/2014, 10:43

... interval between the maximum amplitude of the burst and the last threshold crossing. • event: A microstructural displacement that produces elastic waves in ma- terial under load or stress, which are ... Therefore, the reliability of such structures depends among other influences also on the degree of structural degradation due to fatigue loading. In order to estimate the state of a structure...

Ngày tải lên: 01/07/2014, 10:43

... earthquake loading (Section 3.4), which represents a typical loading scenario that may lead to structural failure induced by low cycle fatigue at highly stressed locations of the structures. 3.3.1.2.1.1 ... mesh dependency of the simulation results due to localisation. The equation for the Rankine damage potential for the tensile domain reads φ t,i (σ, ζ t )=ξ i (σ, ζ t ) −f ct ≤ 0 , (3.69)...

Ngày tải lên: 01/07/2014, 10:43

... [mm] ~ 0.8 20.7 ~ 0.7 ~ 0.8 5.3 5.4 at the end of the numerical design life. However, it must be stated, that with the current design concepts cracks at the stud feet cannot be avoided. 3.3.4.2.8 ... value (5%-fractile) (J Mf,v = 1.0) curve 3: fatigue strength curve – design value (J Mf,v = 1.25) curve 1 65.76 4.1x10 6 } design codes m = 8 (tests S13_2) (tests S13_2) Fig. 3.163. Fa...

Ngày tải lên: 01/07/2014, 10:43

... 4.6 Application of Lifetime-Oriented Analysis and Design 639 (a) experimental setup 0 100 200 300 400 500 600 −80 −60 −40 −20 0 20 discrete ... number of uncertain independent parameters as small as possible. 4.6 Application of Lifetime-Oriented Analysis and Design 643 Fig. 4.177. Bridge near H¨unxe / Germany (span: 62.5m) deterministic ... damage-oriented structural analyses by the...

Ngày tải lên: 01/07/2014, 10:43

... Chennai, India. Cover Design: WMX Design GmbH, Heidelberg. Printed in acid-free paper 30/3100/as 543210 springer.com XII Contents 3.2Experiments 163 3.2.1 LaboratoryTesting of StructuralMaterials ... representing the fields of structural engineering, structural mechanics, soil mechanics, material sci- ence, and numerical mathematics introduced a research program on “lifetime- oriented...

Ngày tải lên: 01/07/2014, 11:20

... loading (Subsections 3.2.1.2 and (Subsections 3.2.2) and structural experiments of steel-concrete composite structures (Subsection 3.2.3). 3.2.1 Laboratory Testing of Structural Materials Authored by Otto T. ... soil. However, excessive settlements of foundations under cyclic loadings may result from unsuitably designed foundations (e.g. inappropriate dimensions, missing soil improvement)...

Ngày tải lên: 01/07/2014, 11:20

Ngày tải lên: 01/07/2014, 11:20

... Rackwitz, R.: Reliability analysis - a review and some perspectives. Structural Safety 23, 365–395 (2001) 654. Rackwitz, R., Fiessler, B.: Structural reliability under combined random load sequences. ... Improved numerical dissipation for the time integration algorithms in structural dynamics. Earthquake Engineer- ing and Structural Dynamics 5, 283–292 (1977) 369. Hillerborg, A., Mod´...

Ngày tải lên: 01/07/2014, 11:20