FACILITIES CRITERIA (UFC) HEATING AND COOLING DISTRIBUTION doc

... INFORMATION 1-1. PURPOSE AND SCOPE. This document provides criteria and guidance for the design and construction of heating and cooling distribution systems and supplements information in ... INFORMATION 1-1. PURPOSE AND SCOPE. This document provides criteria and guidance for the design and construction of heating and cooling distribution systems...

Ngày tải lên: 27/06/2014, 05:20

... \1\ The Unified Facilities Criteria (UFC) system is prescribed by MIL-STD 3007 and provides planning, design, construction, sustainment, restoration, and modernization criteria, and applies to ... Specification 9-4 B-1. Bandwidth and Geometric Mean Frequency of Standard Octave and 1/3 Octave Bands B-6 TM 5-805-4/AFJMAN 32-1090 Table 4-7. Transmission Loss (in dB) of Ply...

Ngày tải lên: 28/03/2014, 18:20

... xc y41 w4 ha" alt="" UFC 3-410-05N 16 January 2004 UNIFIED FACILITIES CRITERIA (UFC) HEATING SYSTEMS OPERATION AND MAINTENANCE Any copyrighted material included in this UFC is ... permission of the copyright holder. U.S. ARMY CORPS OF ENGINEERS NAVAL FACILITIES ENGINEERING COMMAND (Preparing Activity) AIR FORCE CIVIL ENGINEER SUPPORT AGENCY Re...

Ngày tải lên: 27/06/2014, 05:20

... OF MANUAL 1-1. Purpose and scope. This manual provides noise control data and analy- sis procedures for design and construction of die- sel, gas, and gas turbine engine facilities at mili- tary ... new construction and to major alterations of existing structures. U.S. military facilities that require higher standards because of special functions or missions are not covered in th...

Ngày tải lên: 13/02/2014, 23:20

... spaces, for community housing facilities on and off the base, and for per- sonnel involved with the operation and mainte- nance of the engines and plants. 2-4. Vibration criteria. Reciprocating engines ... 3–1 and 3–2 of the N&V manual summarize the octive- band sound pressure levels and the suggested ap- plications of the NC and PNC curves. Also, in the N&V manual,...

Ngày tải lên: 27/06/2014, 05:20

... reads the annual TRNSYS heating and cooling load profile so as to determine the values of the peak heating and cooling loads for each month of the year (see Table 2) and their durations. Moreover, ... geometrical attributes and inf H the factor of opening’s position and air force exposure. Annual heating demand of the building is 33.78 kWh/m 2 whereas cooling dema...

Ngày tải lên: 05/09/2013, 16:10

... Labs Building Energy Consumption [kWh/m 2 /a] IWEC -Heating IWEC -Cooling TMY-2 -Heating TMY-2 -Cooling Figure 6. Energy Consumption per heating/ cooling area of the buildings on annual basis Based ... newer, and hence better insulated, than Block D, it presents higher heating and lower cooling energy demand, even though they are both office buildings with equivalent us...

Ngày tải lên: 05/09/2013, 16:10

... religions and spirituality rooted in the environmental, historical and spiritual context, that offer contextualised answers to daily and fundamental requirements. The extinction of autochthone and ... research must evaluate its processing and its rating criteria. In the following, based on interviews and internet research, explanations from both the German and the Japanese p...

Ngày tải lên: 17/03/2014, 03:20

... n Distinguish between source-rooted and shared distribution trees n Identify the meaning of “push” and “pull” models and their association with dense and sparse mode multicast protocols Copyright ... to: n Distinguish between source-rooted and shared distribution trees n Identify the meaning of push and pull models and their association with dense and sparse mode mul...

Ngày tải lên: 11/12/2013, 14:15