...
survey drawing showed the river towards
the northern part of the site, the waterfall,
and the hillside to the south of the waterfall.
It was clear from the way that the site
plan had been ... life of the building has
given the space its character. is feeling of character
or history, the spirit of a place, is strengthened by the
proportions of th...
... how to measure the
company’s success in the next few years and gauged the prevailing
winds in the firm’s immediate market and in the design field in general.
The last session of the day, which ... clients. They tried to
school themselves in the ways of corporate life. They talked with CEOs
and CFOs. What they learned was that no matter what business they
were in, clients...
... on the top, down one side
of the face, one side of the nose, the upper edge
of the upper lip, the lower lip and the top of the
chin. The eyes are both in shadow, the right one
more so, as are the ... begin on the other colours. I put in
the blue edge to the bowl and then the basic yellow
of the bananas and the yellow and green of the
apples. Nex...
... rendering the document, parsing
through the HTML code and hitting requests for other resources. As it hits these other requests,
it will fetch them from the server the same way it fetched the original ... in the oven before cracking the eggs and mixing the ingredients). This
can be tricky at times, so be careful when thinking about whether mixing up the order of the l...
...
box-sizing
sets the point of
the element from which the width is calculated. The default is
content-box
,
which means the stated width of the element applies to the content, and the
padding ... on as usual.
A value of
border-box
means the stated
width
value is the total width of the
content, the padding, and the border—in other words, the entire b...
...
where w denotes the leg size of the fillet weld measured in centimeter. The
design is found to be safe if the maximum value of the fluctuating stress is
found to be lesser than the design stress. ... the code. This value depends on
a. type of the joint
b. type of stress experienced by the joint
c. a load factor K defined as the ratio of the minimum str...
... is the mass of the belt of unit
length,
m = btρ
(13.1.4)
where, b is the width, t is the thickness and ρ is the density of the belt material.
From the equation of equilibrium in the ... rotating. The basic nature of friction again
suggests that the driven pulley opposes the motion of the belt. The directions of
friction on the belt and...
... ==
For the leather belt, the co-efficient of friction, μ may be taken as 0.4.
In this design, both the pulley materials are assumed to be the same, hence,
angle of wrap for the smaller ... are specified on the following parameters
Material
The decision of the material to be used depends on the type of service.
No. of ply and Thickness
Ply is the...
... from the design table, is the required belt length.
From section (13.3.7) above, the design power and modified power rating of a
belt can be obtained. Therefore,
Design Power
Number of belts
Modified ...
that section for which the required power transmission falls in the lower side of
the given range.
Another restriction of choice of belt section arises f...