Automotive Informatics and Communicative Systems: Principles in Vehicular Networks and Data Exchange ppt

Automotive Informatics and Communicative Systems Principles in Vehicular Networks and Data Exchange

Automotive Informatics and Communicative Systems Principles in Vehicular Networks and Data Exchange

... emerging vehicular networks in the forms of Intra-Vehicle (InV), Vehicle-to-Vehicle ABSTRACT Emerging vehicular networks in the forms of Intra-Vehicle (InV), Vehicle-to-Vehicle (V2V), and Vehicle- to-Infrastructure ... working on advanced automotive technologies in Europe, the United States, Japan, and Singapore. Finally, in the future trend, vehicular networks st...
Ngày tải lên : 25/06/2014, 00:55
  • 364
  • 367
  • 1
Automotive Informatics and Communicative Systems: Principles in Vehicular Networks and Data Exchange ppt

Automotive Informatics and Communicative Systems: Principles in Vehicular Networks and Data Exchange ppt

... Cataloging -in- Publication Data Automotive informatics and communicative systems : principles in vehicular networks and data exchange / Huaqun Guo, editor. p. cm. Includes bibliographical references and index. ... engine management, air-bag deployment, and even in intelligent brake systems. At the same time, emerging vehicular networks in the forms of...
Ngày tải lên : 27/06/2014, 01:21
  • 50
  • 254
  • 0
NEW ADVANCES IN  VEHICULAR TECHNOLOGY  AND AUTOMOTIVE  ENGINEERING    pptx

NEW ADVANCES IN  VEHICULAR TECHNOLOGY  AND AUTOMOTIVE  ENGINEERING    pptx

... physical entrapping of hydrogen in porous materials. Physisorption of H 2 allows fast loading and unloading. Nanostructured New Advances in Vehicular Technology and Automotive Engineering 8 glass ... been solved in modern coatings using nanoscale container (carrying active agents like inhibitors). In this approach, active inhibitor is loaded into nanocontainer. The nan...
Ngày tải lên : 28/06/2014, 10:20
  • 410
  • 355
  • 0
NEW ADVANCES IN  VEHICULAR TECHNOLOGY  AND AUTOMOTIVE  ENGINEERING    pdf

NEW ADVANCES IN  VEHICULAR TECHNOLOGY  AND AUTOMOTIVE  ENGINEERING    pdf

... coating (a) and active material is encapsulated into nanocontainers (b) (Shchukin et al., 2007). New Advances in Vehicular Technology and Automotive Engineering 6 not have intrinsic affinity ... Advances in Vehicular Technology and Automotive Engineering 12 The nanocontainers will be uniformly distributed in coating matrix keeping active materials in a trapped st...
Ngày tải lên : 28/06/2014, 10:20
  • 410
  • 621
  • 1
reaction mechanisms of inorganic and organometallic systems (topics in inorganic chemistry)

reaction mechanisms of inorganic and organometallic systems (topics in inorganic chemistry)

... Some insight into these acronyms and the strengths and weaknesses of various treatments in inorganic systems are provided in reviews by Niu and Hall, 35 Ziegler 36 and Poli and Harvey. 37 ... determining the initial rate is to take the slopes of the lines through the initial points, as shown in Figure 1.2. Strictly speaking, the slopes should be...
Ngày tải lên : 01/04/2014, 10:37
  • 532
  • 346
  • 0
thermoelectric generators for automotive waste heat recovery systems part i numerical modeling and baseline model analysis

thermoelectric generators for automotive waste heat recovery systems part i numerical modeling and baseline model analysis

... Vinning and D. M. Rowe, CRC Handbook of Thermo- electrics, (CRC Press, 1995), pp. 329–337. 11. M.S. Dresselhaus, Y.M. Lin, T. Koga, S.B. Cronin, O. Rabin, M.R. Blackand, and G. Dresselhaus, in ... presented in Table II. RESULTS Varying Inlet Conditions The baseline geometry was tested for varying input conditions, i.e., flow rate and inlet tempera- ture, to capture electrical power...
Ngày tải lên : 06/05/2014, 08:54
  • 10
  • 481
  • 0
thermoelectric generators for automotive waste heat recovery systems part ii parametric evaluation and topological studies

thermoelectric generators for automotive waste heat recovery systems part ii parametric evaluation and topological studies

... transverse and circular configurations (hexagonal and cylindrical) main- taining the same volume as the baseline TEG. Performance analysis of these different topologies and parameters is presented and ... the cylindrical and hexagonal cross-sections as taken from the analysis at average inlet conditions. These arrangements were studied for varying inlet conditions including mass flow...
Ngày tải lên : 06/05/2014, 08:54
  • 12
  • 363
  • 0
thermoelectric generators for automotive waste heat recovery systems part ii parametric evaluation and topological studies

thermoelectric generators for automotive waste heat recovery systems part ii parametric evaluation and topological studies

... transverse and circular configurations (hexagonal and cylindrical) main- taining the same volume as the baseline TEG. Performance analysis of these different topologies and parameters is presented and ... the cylindrical and hexagonal cross-sections as taken from the analysis at average inlet conditions. These arrangements were studied for varying inlet conditions including mass flow...
Ngày tải lên : 06/05/2014, 08:58
  • 12
  • 455
  • 0

Xem thêm