Báo cáo hóa học: " Fabrication of CuO nanoparticle interlinked microsphere cages by solution method" ppt
Báo cáo hóa học: " Fabrication of CuO nanoparticle interlinked microsphere cages by solution method" ppt
... to
convert conventional CuO powders to nanoparticle
interlinked microsphere cages by solution method.
CuO is dissolved into aqueous ammonia, and the
solution is diluted by alcohol and dip coating ... 10.1007/s11671-007-9039-7
123
Experimental
Fabrication of CuO nanoparticle interlinked micro-
sphere cages can be very simple by conversion of
conventional Cu...
Báo cáo hóa học: " Fabrication of ordered nanoporous anodic alumina prepatterned by mold-assisted chemical etching" docx
... used
to achieve prepatterning of Al substrates, thus avoiding
fabrication of the expensive hard imprint stamp. How-
ever most of them have limitations in scalability or size
of ordered domains. Consequently, ... icleu@mail.mse.ncku.edu.tw
2
Department of Materials Science, National University of Tainan, Tainan 700,
Taiwan.
Full list of author information is available at the en...
Báo cáo hóa học: "Fabrication of Uniform Au–Carbon Nanofiber by Two-Step Low Temperature Decomposition" docx
... attach Au nanoparticles to carbon nanostructures [6–8].
For example, Au nanoparticles can be attached to CNTs by
chemical reductions of HAuCl
4
either in a solution of CNT
stabilized by surfactant ... diameter of the Au
nanoparticles and the distance of the bridge in the cross-
linked CNFs is the same as the diameter of AAO channel
suggests that the fibers are the splits of t...
Báo cáo hóa học: " Fabrication of core/shell ZnWO4/carbon nanorods and their Li electroactivity" ppt
... stretching modes caused by
each of the six W-O bonds in the WO
6
octahedrons. In
the case of Raman analysis, group theory analysis of
wolframite-type ZnWO
4
predicts 36 lattice modes, of
which 18 even ... performed for further sample
analysis. The electrochemical performance of the sam-
ples versus that of lithium was measured by means of a
multichannel potentiostati c/galva...
báo cáo hóa học: " Fabrication of flexible UV nanoimprint mold with fluorinated polymer-coated PET film" docx
... flexible PET
film by hot embossing lithography with high fidelity and
without any defects . Due to the slightly tapered profile
of the patterns of the Si master mold and elastic nature
of the hot embossing ... procedure
Fabrication of flexible UV nanoimprint mold
Figure 1 shows experimental schematics and detailed
process flow of hot embossing litho graphy system and
UV nanoimpr...
Báo cáo hóa học: " Fabrication of HfO2 patterns by laser interference nanolithography and selective dry etching for III-V CMOS application" pdf
... 6:400
http://www.nanoscalereslett.com/content/6/1/400
Page 4 of 6
power to lessen the re-deposition of non-volatile by- pro-
ducts, in combination with the use of more benign
cleaning solutions than HCl/H
2
O,aresomeofthe
future improvements ... Patterning of the
photoresist by laser interference lithography. (c) Pattern transfer to the SiO
2
layer by CF
4
ICP-RIE. (d) Pattern tr...
Báo cáo hóa học: " Fabrication of functional micro- and nanoneedle electrodes using a carbon nanotube template and electrodeposition" ppt
... Research
Foundation of Korea funded by the Ministry of Education, Science and
Technology (R31-2008-000-10105-0). This work was supported by the
National Research Foundation of Korea (NRF) grant funded by the ... con-
trolled by changing the concentration of the suspension,
the amplitude of the AC voltage, and the collection time
[22,23]. The length of the CNT nanoneedle wa...
Báo cáo hóa học: " Fabrication of complete titania nanoporous structures via electrochemical anodization of Ti" docx
... 6:332
http://www.nanoscalereslett.com/content/6/1/332
Page 6 of 10
dissolution power of the HF-based electrolyte where
TiO
2
dissolution is very fast compared to the EG elec-
trolyte [28]. The dissolution power of the HF-based
electrolyte ... the content of F
in the t op and bottom surface of TNP in the EDX ana-
lysis (Table 1). However, dissolution of the F-rich layer
between the...
Báo cáo hóa học: " Fabrication of Porous TiO2 Hollow Spheres and Their Application in Gas Sensing" pdf
... absorbencies of the MB solution
before and after mixing, respectively; V is the volume of
the solution, and m is the mass of TiO
2
sample.)
From the Table 1, it can be seen that 96*98% of MB in
the solution ... controlled by adjusting the reaction
time in our experiments.
To investigate the adsorption property of synthesized
products, 0.1 g of sample was added into 100 mL...
báo cáo hóa học:" Fabrication of a new type of organic-inorganic hybrid superlattice films combined with titanium oxide and polydiacetylene" ppt
... consisted of ten [TiOPDA (0.6 nm)/TiO
2
(2.3
nm)] bilayer subunits. The thermal stability of the
TiOPDA-TiO
2
films was studied by using TEM. The
films were stable in air up to temperatures of about
400°C. ... sharp
interfaces.
Acknowledgements
This work was supported by the Seoul R&BD program (ST090839) and by
the Korea Science and Engineering Foundation (KOSEF) funded by t...