The Risk Management of Safety and Dependability 6 pot
The Risk Management of Safety and Dependability_1 pot
... to the principles of risk management 1 1.1 Introduction 1 1.2 The principles of risk assessment 2 1.3 The risk assessment matrix 3 1.4 Risk evaluation and control 4 1.5 Dependability 5 1 .6 The ... protection. As the city grew, a risk assessment of the adequacy of the design standard was never under- taken. The fi nal report recommended that the whol...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_2 potx
... ensure the health and safety of the workforce, including the subcontractors. In general the regulations reinforce the requirements of the Health and Safety at Work Act, The Management of Health and ... to: 26 The risk management of safety and dependability © Woodhead Publishing Limited, 2010 There are many other regulations tha...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_5 pot
... the number of items available, 4 in the example r is the number required, 2 in the example P is the probability of failure of each item. 1 36 The risk management of safety and dependability ... elements fails then the whole control system fails. If the control system fails, then the system depends on the reliability of the pressure...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_6 pot
... explosion of 0.0000 067 , the probability of a worker being killed is: 0.0000 067 × 33 .6/ 8000 = almost none. In addition there will be the need for the maintenance inspection and testing of the PAHH and ... injured they must be there and when the explo- sion occurs. Therefore the chance of being there times the probability of an explosion gives the probabi...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_7 pot
... 25.89 2 86. 46 86. 46 75.14 65 .74 58.18 52.07 47.07 42.91 39.42 3 98.30 90.24 81.07 72.87 65 .87 59.97 54. 96 50 .69 4 98.73 92. 36 84 .68 77.47 71.08 65 .51 60 .66 5 98.98 93.72 87.12 80.71 74. 86 69 .65 6 99.15 ... between the shaft and the casing. These instruments are used to measure the relative motion of the machine shaft and the machine casing. They respo...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_8 pdf
... depend on the relative areas, the distance apart, the resistivity of the electrolyte and the chemical composition of the fl uid. 2 06 The risk management of safety and dependability ... crane working on the construction of a block of fl ats collapsed. The driver was killed as was a member of the public who 198 The r...
Ngày tải lên: 21/06/2014, 12:20
The Risk Management of Safety and Dependability_10 pdf
... limits, 65 radiation, 62 –3 heat, 62 ionising, 63 light, 62 non-ionising, 62 waste emissions, 48– 56 air emission effects and exposure limits, 52 262 The risk management of safety and dependability ... reliability, 267 hazards of change, 266 –7 present day, 268 safety case, 267 –8 work permit system, 267 condensate pump arrangement, 263 destroyed, 263 eve...
Ngày tải lên: 21/06/2014, 12:20
The risk management of safety and dependability_1 pot
... view of pontoon and walkway. 56 The risk management of safety and dependability © Woodhead Publishing Limited, 2010 4, 3 and 2 correspond to the UN Packaging Groups I, II and III ... the villagers of Minamata living off the fi sh from the bay suffered mercury poisoning, which attacked the brain and kidneys and affected their nervous syst...
Ngày tải lên: 21/06/2014, 23:20
The risk management of safety and dependability_3 pot
... elements fails then the whole control system fails. If the control system fails, then the system depends on the reliability of the pressure safety relief valve on the vessel. The safety of the manual ... function. The probability of reliability and the probability of failure are opposite sides of the same coin. Therefore if P is the probability of...
Ngày tải lên: 21/06/2014, 23:20
The risk management of safety and dependability_5 doc
... 25.89 2 86. 46 86. 46 75.14 65 .74 58.18 52.07 47.07 42.91 39.42 3 98.30 90.24 81.07 72.87 65 .87 59.97 54. 96 50 .69 4 98.73 92. 36 84 .68 77.47 71.08 65 .51 60 .66 5 98.98 93.72 87.12 80.71 74. 86 69 .65 6 99.15 ... Suspended 3 1504 2 Failure 2. 166 6 1. 866 6 0.252 4 2250 Suspended 5 3200 3 Failure 3 .62 46 3.32 46 0.4492 6 4200 4 Failure 5.0830 4.783 0 .64 63 7 5400 5 Fai...
Ngày tải lên: 21/06/2014, 23:20