Báo cáo hóa học: "Preparation and evaluation of novel mixed micelles as nanocarriers for intravenous delivery of propofol" potx
Báo cáo hóa học: "Preparation and evaluation of novel mixed micelles as nanocarriers for intravenous delivery of propofol" potx
... fusion of the drug from inne r phase and then
slower release. Ne vertheless, the release rate of mixed
micelles was faster than that of CLE before the first 12
h, the release rate of the two formulations ... 6:275
http://www.nanoscalereslett.com/content/6/1/275
Page 8 of 9
NANO EXPRESS Open Access
Preparation and evaluation of novel mixed micelles
as nanocarrier...
báo cáo hóa học: " Development and evaluation of a computer-based medical work assessment programme" pdf
... explanations of individual differences in task
performance as well as among hospitals and other medi-
cal professions.
As a point of criticism, using this methodology is very
time and effort intensive; ... proved a high level of
similarity – an important outcome measure for the job
task analysis. The process of developing the software and
the task lists would likely be s...
Báo cáo hóa học: " Development and evaluation of one step single tube multiplex RT-PCR for rapid detection and typing of dengue viruses" pdf
... this assay.
Evaluation of Multiplex RT-PCR
The feasibility of the assay for clinical diagnosis was vali-
dated by evaluating with serum samples from 620 acute-
phase suspected patients and 40 ... Ts3 and
Ts4).
Evaluation of multiplex RT-PCR
The evaluation of the multiplex RT-PCR assay was carried
out with 620 serum samples collected over a period of six
years from India....
báo cáo hóa học:" Development and evaluation of a clinical algorithm to monitor patients on antiretrovirals in resource-limited settings using adherence, clinical and CD4 cell count criteria" ppt
... HIV p24 based assays [7];
reverse transcriptase based assays [8]; filter paper transfer
of whole blood or plasma for distant site bulk RNA quan-
tification [9]; and qualitative dipstick assays ... utility of monitoring algorithms
The performance of the algorithms was assessed by sensi-
tivity, specificity, and positive and negative predictive
value, and then compared to an alg...
Báo cáo hóa học: " Preparation and characterization of superhydrophobic surfaces based on hexamethyldisilazane-modified nanoporous alumina" pptx
... participated in the design of the
study and coordination of the work. All authors contributed to interpretation
of the results and drafting of the manuscript and they read and approved
the final ... chemical modification of the
surface with surface roughness. This idea was indepen-
dently established by Wenzel [6] and Cassie and Baxter
[7], and the wetting of rough s...
Báo cáo hóa học: " Preparation and properties of copper-oil-based nanofluids" ppt
... Therefore, the formatio n of nanofluids has no sig-
nificant effect upon the viscous resistance.
Thermal conductivities of the nanofluids for different
fluid-based nanofluids as a function of mass ... that of a pure base liquid. It increases
somewhat with increasing concentration of the nanopar-
ticles. The addition of nanoparticles with 1% of mass
fraction leads to no more...
Báo cáo hóa học: "Preparation and characterization of carbon nanofluid by a plasma arc nanoparticles synthesis system" pot
... conductivity and feasibility for manufacturing of carbon/water nanofluids.
Introduction
As industrial and technological products demand higher
standards of function and capacity, the problem of heat
dissipation ... SiC, and carbon nanotube nanofluid. In general,
two-step syntheses are more suitable for the preparation
of oxide nanofluids, but are less appropriate for t...
Báo cáo hóa học: " Preparation and thermal conductivity of CuO nanofluid via a wet chemical method" potx
... conductivity of CuO nanofluids
Figure 6 shows the thermal conductivity ratio of the
typical sample, defined as k/k
0
,wherek and k
0
are the
thermal conductivities of the nanofluids and the base
media ... concept of
nanofluid was proposed [1], more and more researchers
have been committing to it because of the thermal prop-
erties and the potential applications associated...
Báo cáo hóa học: " Preparation and characterization of spindle-like Fe3O4 mesoporous nanoparticles" pot
... flask (100 ml) and heated to 95°C. Then
1.8 ml of FeCl
3
solution (1.48 mol l
-1
) w as added drop-
wise into the flask, and themixturewasagedat100°C
for 14 h. After the resulting mixture was ... product was
centrifuged and washed with d ouble distilled water and
ethanol. The as- obtained a-Fe
2
O
3
NPs was labeled as
S1. The dried a-Fe
2
O
3
powder was annealed at 250,
300,...
Báo cáo hóa học: "Preparation and Characterization of Silica-Coated Magnetic–Fluorescent Bifunctional Microspheres" ppt
... synthesized as reported by
Massart et al. [28]. A mixture of 5.406 g of FeCl
3
Á6H
2
O
and 2.780 g of FeCl
2
Á4H
2
O dissolved in 100 mL of high-
purity water was placed in a 250-mL flask, following ... intensity increased with the decrease in the
amount of TEOS, and reached a maximum when TEOS
was 1.5 mL. If the amount of TEOS was too low, a silica
shell did not form on the...