Advances in Gas Turbine Technology Part 14 pdf

... one of using operating turbine blade with excellent mechanic property. IN7 38 alloy with excellent hot corrosion resistance was broadly using to produce industrial gas turbine blades. In this ... developed by Institute of Metal Research; Chinese Academy of Sciences (IMR, CAS) based Advances in Gas Turbine Technology 392 compared to the plasma spraying with shot pe...

Ngày tải lên: 21/06/2014, 02:20

... pressure turbine. Significant business case 18 Advances in Gas Turbine Technology Contents Preface IX Part 1 Aero and Marine Gas Turbines 1 Chapter 1 Future Aero Engine Designs: ... Increasing of Ship Propulsion and Marine Power Plant with the System Combined of Marine Diesel Engine, Gas Turbine and Steam Turbine 45 Marek Dzida Part 2 Gas Turbine...

Ngày tải lên: 21/06/2014, 02:20

... compressed using the energy contained only in part of the exhaust gas flow. The remaining part of the exhaust gas flow can be expanded in an additional gas turbine, the so-called power turbine, which ... 2007). Interacting with secondary flows, shock waves concur in development of blockage (Suder, 1998), in corner Advances in Gas Turbine Technology 48 exh...

Ngày tải lên: 21/06/2014, 02:20

... cannot be used to increase the power of the turbine. Advances in Gas Turbine Technology 114 Ferrari, M. L., Pascenti, M., Magistri, L., Massardo, A. F. (2010c), Micro Gas Turbine Recuperator: ... decrease in the efficiency of combustion in gas turbine as the percentage of biodiesel in the blend increase. In terms of emissions, an increase of CO content...

Ngày tải lên: 21/06/2014, 02:20

... problems concerning pumping and spraying (heating, filtration etc.). When considering using aviation gas turbines for industrial purposes (existing aviation gas turbines with minimal modifications) ... the flue gases exhausted from the gas turbine depend on the fuel type, load, fluid injection in the gas turbine (water, steam), environmental conditions etc. The gas turbin...

Ngày tải lên: 21/06/2014, 02:20

... However the initial model training is a nonlinear optimization problem, requiring conjugate Advances in Gas Turbine Technology 192 Fig. 2. A schematic of a cutaway of a small gas turbine. 2. ... the modern gas turbine with common cooling blade techniques. Jet Impingement Cooling in Gas Turbines for Improving Thermal Efficiency and Power Density 193 3. Typ...

Ngày tải lên: 21/06/2014, 02:20

... direct influence on the turbine life span. Fig. 6. Adiabatic compressor map with operating points in the three configurations Advances in Gas Turbine Technology 214 P i3 : turbine inlet ... flow, single-shaft gas turbine In conventional machines, calculations are usually done by assuming that the gas turbine is adiabatic (q = 0). The adiabatic versi...

Ngày tải lên: 21/06/2014, 02:20

... 1979. Advances in Gas Turbine Technology 278 8.5 Initial particle speed It is difficult to determine the initial particle speed given that the fuel is injected via the tube into the injector ... Advances in Gas Turbine Technology 262 Becker, B. & Schetter, B. (1992). Gas Turbines Above 150 MW for Integrated Coal Gasification Combined Cycles (IGCC), Trans...

Ngày tải lên: 21/06/2014, 02:20

... stress and strain at the node adjacent to the notch root. Fig. 12. ABAQUS modelling of a stress-strain loop at 20⁰C in Ti6246 (Whittaker et. al., 2010a). Advances in Gas Turbine Technology ... Science, technology and applications of Ti 1970 pp 933-936. Titanium in the Gas Turbine Engine 331 mechanical testing aimed at detailing these variations in a range...

Ngày tải lên: 21/06/2014, 02:20

... however, are investigation of influence of particle size distribution. In next section, the influence of the particle size distribution is explained. Advances in Gas Turbine Technology ... N 2 gas Advances in Gas Turbine Technology 512 5.2 Grain structure study via electron back scattering diffraction (EBSD) From SEM observations, the grains in the as-s...

Ngày tải lên: 21/06/2014, 02:20