Advanced Microwave Circuits and Systems Part 11 ppt

... isolation between ports 1 and 4, and 2 and 3 is greater than 19 dB in the 3.1 to 10.6 GHz frequency band. In the same band, the coupling between ports 1 and 3 and 2 and 4 is 3 dB with a ±1 dB ... the reference to Port 1 and 2 Advanced Microwave Circuits and Systems3 54 The simulated magnitudes of q 4 , q 5 , q 6 and q 7 are 2.3 ± 0.9, 1.9 ± 0.8, 2.1 ± 0.6 and 2.5 ± 0....

Ngày tải lên: 20/06/2014, 11:20

... a 2D MRT cross section. Figure 8 shows this process. Advanced Microwave Circuits and Systems4 34 In order to decode the data, the digital part also requires a clock signal that is several times ... capacitance to limit simulation time) Advanced Microwave Circuits and Systems4 18 Fig. 10. Equivalent Circuit of a Transponder maximum possible distance between reader and transponder. It...

Ngày tải lên: 20/06/2014, 11:20

... 2006. Advanced Microwave Circuits and Systems4 84 exciting monopole antenna is positioned at the top of the silo’s lid below the microwave source. (a) (b) Fig. 11. Design and simulation ... between larvae and adults mortality rate of Tribolium and Sitophilus Granarius exposed to microwave radiation (2.44 GHz) in terms of exposed time Advanced Microwave Circuits...

Ngày tải lên: 20/06/2014, 11:20

... Main device maximum allowable output current I Max and its selected bias point. Advanced Microwave Circuits and Systems1 18 Now, from (15) and replacing the respective Fourier expressions, it ... is Advanced Microwave Circuits and Systems1 14 Clearly, eqn. (6) is based on the assumption that only the Main amplifier delivers output power until the break point condition is reached,...

Ngày tải lên: 20/06/2014, 11:20

... t SiN ranging from 30 to 50nm and L FP ranging from 0.4 and 0.6m. Advanced Microwave Circuits and Systems1 98 Asano K., Miyoshi Y., Ishikura K., Nashimoto Y., Kuzuhara M., and Mizuta M. (1998) “Novel ... plated devices are obtained with t SiN ranging from 30 to 50nm and L FP ranging from 0.4 and 0.6m. Advanced Microwave Circuits and Systems1 78 pointing out that beside inc...

Ngày tải lên: 20/06/2014, 11:20

... Advanced Microwave Circuits and Systems2 14 2. Proposed process and main experimental parameters 2.1 Wavelength bands of generated radiation To start ... push-pull buffer pair is shown in Fig. 3, and the standard 150-µm pitch gsgsg probe pad layout depicted underlines the compact size Advanced Microwave Circuits and Systems2 32 Table 1. Comparison of push-pull ... consumption and...

Ngày tải lên: 20/06/2014, 11:20

... phones or other handheld wireless products. The choice 13 Advanced Microwave Circuits and Systems2 66 good dielectric material should have a high dielectric constant, a high band gap to limit ... the energies stored in the magnetic and electric fields and lost can be expresses in eqation (3.8 to 3.10) respectively. Advanced Microwave Circuits and Systems2 68 size (Wu J. C. & Z...

Ngày tải lên: 20/06/2014, 11:20

... N=M=4 N=M=5 N=M=6 N=M=7 Advanced Microwave Circuits and Systems4 80 temperatures and using less power in the lower bands rather than microwave band. The complex dielectric constant of one kind of rice weevils and ... sensitive to the temperature increase. Advanced Microwave Circuits and Systems4 54 7. References Andersen J.B. and Vaughan R.G. (2003) Transmitting, receiving...

Ngày tải lên: 20/06/2014, 11:20

Ngày tải lên: 24/12/2013, 01:16

... small (a few micrometers in length and width, and less than 1 μm thick) [11] , therefore usually producing very low electrical output power (in order of nano- watts) and operate at high level of vibration ... fabricating and characterising free-standing thick-film piezoelectric cantilevers for energy harvesting. Firstly the research requires the understanding of the process conditi...

Ngày tải lên: 19/06/2014, 08:20