Tribology Lubricants and Lubrication 2012 Part 6 potx

Tribology Lubricants and Lubrication 2012 Part 6 potx

Tribology Lubricants and Lubrication 2012 Part 6 potx

... d m 0,4 167 1,0 966 D – d m 1,7114 0,9481 C – d m 69 ,121 1 ,66 75 C 0 – d m 22,552 1,9273 Full complement cylindrical roller bearings c  d  d – d m 0,4595 1,0951 D – d m 1 ,69 61 0,9399 C ... algorithm Tribology - Lubricants and Lubrication 1 26 The functions between the bearing geometry and load carrying capacity for of CARB toroidal roller bearings [Fig....

Ngày tải lên: 19/06/2014, 15:20

25 313 0
Tribology Lubricants and Lubrication 2012 Part 1 potx

Tribology Lubricants and Lubrication 2012 Part 1 potx

... orders@intechweb.org Tribology - Lubricants and Lubrication, Edited by Chang-Hung Kuo p. cm. ISBN 978-953-307-371-2 Tribology - Lubricants and Lubrication 6 are defined and can be derived ... Che Sidik and Syahrullail Samion Chapter 7 Biodegradable Lubricants and Their Production Via Chemical Catalysis 185 José André Cavalcanti da Silva Tribology...

Ngày tải lên: 19/06/2014, 15:20

25 347 0
Tribology Lubricants and Lubrication 2012 Part 5 potx

Tribology Lubricants and Lubrication 2012 Part 5 potx

... Tribology - Lubricants and Lubrication 1 06 leakage of lubrication in the bearing ends *3 ,Q м s and temperature of the lubricant film ,TC D . 3. Lubrication with non-Newtonian and multiphase ... fluid 61 0,5 105,9 0,02345 4,4 16 280,3 1,93 0 Structural-viscous liquid (28) 518,4 102 ,6 0,02512 3,75 309,8 1,52 16, 9 Structural-viscous liquid (29) 539,0 103,4 0...

Ngày tải lên: 19/06/2014, 15:20

25 450 0
Tribology Lubricants and Lubrication 2012 Part 14 doc

Tribology Lubricants and Lubrication 2012 Part 14 doc

... additive's influence on the pitting and wear of ball bearing steel. Wear, Vol. 192, pp. 66 -73, ISSN 0043- 164 8 Tribology - Lubricants and Lubrication 3 16 The test method has been successfully ... international and national standards can be Tribology - Lubricants and Lubrication 320 Michalczewski, R. (2008). Chemomechanical synergy of PVD/CVD coatings...

Ngày tải lên: 19/06/2014, 14:20

5 264 0
Tribology Lubricants and Lubrication 2012 Part 2 docx

Tribology Lubricants and Lubrication 2012 Part 2 docx

... ⎦ ⎣ ⎦     where, 16 1C = and 26 36 46 56 66 ,,,,CCCCC concern the solution of Reynolds equation which governs the hydrodynamic lubrication behaviors between skirt and bore surfaces and cannot be ... ⎤ ⎣⎦ ′′′′ +⋅++⋅++     () () () 2 2 65 6 56 757 57 OX P OY P R C Y FWWWWWmFYS FWWWWWFYmmm g θ θ ⎡⎤ ⎣⎦ ′′′ =+⋅+⋅+⋅− ′′′′ = +⋅ + ⋅ ++ ++⋅   Then the output matrix...

Ngày tải lên: 19/06/2014, 15:20

25 273 0
Tribology Lubricants and Lubrication 2012 Part 3 docx

Tribology Lubricants and Lubrication 2012 Part 3 docx

... Swahn et al., 1976a, 1976b; Voskamp, 19 96) . For the automobile alternator and gearbox ball bearing from rig tests, N° 1 and N° 2 in Figure 20a, respectively, b/B equals about 0 .61 and 0.57. Metallography ... (Olver, 2005). New aspects of rolling contact tribology in bearing failures are presented in the following. Tribology - Lubricants and Lubrication 46 typic...

Ngày tải lên: 19/06/2014, 15:20

25 294 0
Tribology Lubricants and Lubrication 2012 Part 4 pptx

Tribology Lubricants and Lubrication 2012 Part 4 pptx

... Tribology - Lubricants and Lubrication 86 Fig. 69 . Investigation of the fracture surface of Figure 67 in the deep corrosion fatigue crack region revealing (a) a SEM-SE fractograph and ... sides and on the surface. The distinct change of the fracture pattern in Figures 66 and 67 , respectively with a demarcating bulge or crack network, on the latter of which Fig...

Ngày tải lên: 19/06/2014, 15:20

25 310 0
Tribology Lubricants and Lubrication 2012 Part 7 pdf

Tribology Lubricants and Lubrication 2012 Part 7 pdf

... damage) and outer radii r 1 = 0.3 06 m and r 2 = 0.315 m, Tribology - Lubricants and Lubrication 160 of the presence of elastic soil the difference between the results of the analytical and ... damage are, on average, only 6 and 3% , respectively. Maximum and minimum values of σ t in the calculation for (1), (6) are: min 6 1.27 10 t σ =− ⋅ Pa and max 5 7....

Ngày tải lên: 19/06/2014, 15:20

25 312 0
Tribology Lubricants and Lubrication 2012 Part 8 pptx

Tribology Lubricants and Lubrication 2012 Part 8 pptx

... several standards and specifications for fourball machine: such as Socialist Republic of Romania State Standard 861 8-70; FTM no. 791 a /65 03; ASTM D25 96- 67 and DIN 51350 (Ivan, 1980). Boundary lubrication ... mineral oil Tribology - Lubricants and Lubrication 184 Sevim, Z.E, Brajendra, K.S. and Joseph, M.P., 20 06, “Oxidation and Low Temperature Stability of Ve...

Ngày tải lên: 19/06/2014, 15:20

25 267 0
Tribology Lubricants and Lubrication 2012 Part 9 pot

Tribology Lubricants and Lubrication 2012 Part 9 pot

... °C 3 960 0 3 965 0 3 968 0 39700 39710 39750 39891 ASTM D- 189 Yield stress, D/cm 2 60 .2 61 .3 62 .1 62 .9 63 .6 64.3 65 .0 Four ball weld load, Kg 160 162 165 166 168 169 170 ASTM D- 25 96 Table ... ASTM D- 566 Oxidation Stability 99±96h, pressure, drop, psi 3.5 3.2 3.0 ASTM D-942 Alkalinity, Wt% 0. 16 0.14 0.14 ASTM D -66 4 Total acid number, mg KOH/g, @72h 0.20...

Ngày tải lên: 19/06/2014, 15:20

25 335 0
w