Lasers Applications in Science and Industry Part 6 pptx

... quality while introducing a minor increase in the size of the object, all without changing the optical imaging parameters. Lasers – Applications in Science and Industry 96 1.2 Pulsed laser ... (1) w - grating period λ - desorbing laser wave length Part 2 Laser-Matter Interaction Lasers – Applications in Science and Industry 110 Fig. 1. Laser-matt...

Ngày tải lên: 18/06/2014, 22:20

... aluminum alloy is about twice that of the 2024 aluminum alloy. Lasers – Applications in Science and Industry 174 Fig. 1. Schematic representation of propagation of pitting corrosion in ... Electric Co., DL708E). Lasers – Applications in Science and Industry 1 86 Fig. 18. Changes in rest potential after the re-activation of 2024 aluminum alloy i...

Ngày tải lên: 18/06/2014, 22:20

... volume, as shown in Figs. 8 and Fig. 9. Lasers – Applications in Science and Industry 218 irradiation of a certain number of laser pulses. The laser ablation and OCT imaging are repeated ... wavelength-swept laser Lasers – Applications in Science and Industry 2 16 al. 2005; Ohmi et al. 2007). In the traditional OCT system using a super-luminescen...

Ngày tải lên: 18/06/2014, 22:20

... Lasers – Applications in Science and Industry 8 temperature of the ZnSe crystals increases. In the case of pulse lasers, an increases in the transient temperature ΔT in materials ... hexagonal and the orientation of each diffraction point is Lasers – Applications in Science and Industry Edited by Krzysztof Jakubczak Published by In...

Ngày tải lên: 18/06/2014, 22:20

... shown in Fig. 11(a). Lasers – Applications in Science and Industry 28 4. Depositing high LIDT coatings at Sandia’s large optics coating operation Coating large optics goes hand in hand with ... detail in this chapter. Regarding the polishing and preparing of optics for coating, we have demonstrated in the case of an AR coating that using one combination of polish...

Ngày tải lên: 18/06/2014, 22:20

... coating design plays in obtaining coatings Lasers – Applications in Science and Industry 42 and this interference leads to intensity peaks well below the incident intensity except in the ... Side 1 coating must not only offer very uniform Lasers – Applications in Science and Industry 50 Regarding polishing, washing and cleaning of an optic prior to c...

Ngày tải lên: 18/06/2014, 22:20

... 20 minutes. Fig. 1. PLD general setup used in the experiments reviewed in this chapter Lasers – Applications in Science and Industry 66 to the vibration bath, which results in heating ... coupling Lasers – Applications in Science and Industry 58 We observed that only AlN was detected in the films obtained with laser sources B and C, while fil...

Ngày tải lên: 18/06/2014, 22:20

... pp 69 37- 69 39; ISSN 1089-7550 Lasers – Applications in Science and Industry 76 the experimental and theoretical characterizations of the bumps are demonstrated. In the second part, we expand ... itself and remains in the equilibrium state, and thus inherits the structure and volume at the melting state. Therefore, the volume has an increase V , and La...

Ngày tải lên: 18/06/2014, 22:20

... of China (Grant No. 60 890203 and 1 067 6023) and the Young Faculty Research Fund of Sichuan University (Grant No. 2009SCU11008). Lasers – Applications in Science and Industry 1 16 In order ... fiber and supercontinuum spectrum. (Courtesy of Dr. Ping Ying and Dr. Zairu Ma) Lasers – Applications in Science and Industry 120 Fig. 3.5. The ripples...

Ngày tải lên: 18/06/2014, 22:20

... eliminate the flash from ablation and to record the image as shadowgraphs. Lasers – Applications in Science and Industry 1 36 glass plates with PMMA block, we observed the detonation-induced ... treated in this chapter is the difference in refractive index of a transparent material from that of the adjacent medium. Lasers – Applications in Science and In...

Ngày tải lên: 18/06/2014, 22:20