Toyota camry 2006 2011 CAN communication hệ thống CAN liên lạc trên toyota camry đời 2006 2011

... (A40) Rear of the Vehicle (E41) No. 2 CAN J/C CANH CANL CANH CANLCANH CANLCANH CANL CANH CANL CANH CANL CANH CANL CANH CANL CANH CANL CANH CANL CANH CANL CANH CANL No. 1 CAN J/C Skid Control ECU with ... CAN COMMUNICATION SYSTEM CA–15 CA E41-7 (CANL) W Accessory Gateway (CANL) E41-2 (CANH) B A/C Amplifier (CANH) E41-8 (CANL) W A/C Amplifier (CANL) E41-4 (CANH) B No. 1 CAN J/C (CAN...

Ngày tải lên: 24/05/2014, 13:27

Ngày tải lên: 24/05/2014, 13:42

... floor carpet assembly until the bolts of the cross member floor No. 4 reinforcement sub-assembly can be seen. 44. REMOVE CROSS MEMBER FLOOR NO. 4 REINFORCEMENT SUB-ASSEMBLY (a) Remove the 8 bolts ... expand the shoe until the disc locks. (d) Turn and contract the shoe adjuster until the disc can rotate smoothly. Standard: Return 8 notches (e) Check that there is no brake drag against...

Ngày tải lên: 24/05/2014, 13:49

... fuse DBE+ DBE- CANH CANL : CAN 18 13 22 11 12 1 3 17 12 E2 CANH F1 N3 CANL 13 IG+ B137085E01 Result Proceed to Output DTC (CAN communication) A Output DTC (Airbag system) B No output DTC C GO TO CAN COMMUNICATION ... Sensor FL Road Sensor FR Road Sensor RL SV3 SIG3 SGD3 FSR+ FSR- FSP+ FSP- CANH CANL CANH 9 P/SB CANL 19 10 PBEW GND1 IG 3 SV4 : CAN SIG4 SGD4 SV2 SIG2 SGD2 SV1 SIG1 SGD...

Ngày tải lên: 24/05/2014, 13:50

... positive Always 11 to 14 V CANH (6) - CANL (14) CAN bus line Ignition switch off* 54 to 69 Ω CANH (6) - CG (4) CAN bus line Ignition switch off* 200 Ω or higher CANL (14) - CG (4) CAN bus line Ignition ... CAN bus line Ignition switch off* 200 Ω or higher CANH (6) - BAT (16) CAN bus line Ignition switch off* 6 kΩ or higher CANL (14) - BAT (16) CAN bus line Ignition switch off* 6 k...

Ngày tải lên: 24/05/2014, 13:50

... WORKSHOP 2 INSPECT BATTERY VOLTAGE 3 CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* Result Proceed to CAN DTC is not output A CAN DTC is output B Go to CAN COMMUNICATION SYSTEM 4 CHECK FOR DTC* Result ... pressure sensor Ignition switch on (IG) A/C switch: OFF Below 1 V E38-11 (CANH) - E38-12 (CANL) B - W CAN communication system CAN communication circuit Pu...

Ngày tải lên: 24/05/2014, 13:13

... Radio receiver AV-145 Radio broadcast cannot be received or poor reception. Proceed to "Radio Broadcast cannot be Received or Poor Reception" AV-76 CD cannot be inserted / played or CD ... to "CD cannot be Inserted / Played or CD is Ejected Right After Insertion" AV-72 CD cannot be ejected. 1. Radio receiver power source circuit AV-140 2. Proceed to "CD cannot be .....

Ngày tải lên: 24/05/2014, 13:15

... mode. 3. CAN COMMUNICATION SYSTEM PRECAUTION (a) The CAN communication system is used for data communication between each of the ECUs and sensors. If there is trouble in the CAN communication ... Always 9 to 14 V CANH (6) - CANL (14) HIGH-level CAN bus line Ignition switch OFF* 54 to 69 Ω CANH (6) - Battery positive HIGH-level CAN bus line Ignition switch OFF* 6 kΩ or highe...

Ngày tải lên: 24/05/2014, 13:23

... to 14 V CANH (6) - CANL (14) CAN bus line Ignition switch off * 54 to 69 Ω CANH (6) - CG (4) HIGH-level CAN bus line Ignition switch off * 200 Ω or higher CANL (14) - CG (4) LOW-level CAN bus ... meter or the CAN communication and multiplex communication systems. Use the intelligent tester to check and solve the problem. 2. CHECK DLC3 (a) The ECU uses the ISO 15765-4 for commun...

Ngày tải lên: 24/05/2014, 13:28

... 10 to 14 V CANH (6) - CANL (14) CAN bus line Ignition Switch OFF* 54 to 69 Ω CANH (6) - CG (4) HIGH-level CAN bus line Ignition Switch OFF* 200 Ω or more CANL (14) - CG (4) LOW-level CAN bus line ... bus line Ignition Switch OFF* 200 Ω or more CANH (6) - BAT (16) HIGH-level CAN bus line Ignition Switch OFF* 6 kΩ or more CANL (14) - BAT (16) LOW-level CAN bus line Ignition Switch OFF...

Ngày tải lên: 24/05/2014, 13:29