Pages from modern control engineering

modern control engineering, 4th edtion (2002)- ogata

modern control engineering, 4th edtion (2002)- ogata

... varied by the controller so as to affect the value of the controlled variable. Normally, the controlled variable is the output of the system. Control means measuring the value of the controlled ... signal, output signal, and signals from sensors from disturbance sources. The controller sends out an optimal control signal to the air conditioner or heater to control the amount of...
Ngày tải lên : 01/04/2014, 11:05
  • 978
  • 532
  • 0
Control engineering - a guide for beginners

Control engineering - a guide for beginners

... even shorter. ! industrial process control ! drive control (speed control) ! control of electrical variables ! positional control ! course control Control Engineering A guide for beginners Manfred ... 10V. They are used to control valve drives or thyristor units. - Discontinuous controllers 2-state controllers (single-setpoint controllers) with one switching output are contro...
Ngày tải lên : 13/12/2013, 00:14
  • 132
  • 353
  • 0
Advanced control engineering   roland s burns

Advanced control engineering roland s burns

... sensor and controller as shown in Figure 1.5. Disturbance Input Control Input Controlled Variable or Output + Summing Point Plant – Fig. 1.4 Plant inputs and outputs. Forward Path Controller Control Signal Summing Point Error Signal Output Value • Measured ... control signal, Desired Angle Desired Angle Control Column Control Column Actual Angle Actual Angle Measured AngleMeasured A...
Ngày tải lên : 01/01/2014, 18:39
  • 465
  • 325
  • 7
Digital control engineering  analisys and desing   m  sam fadali

Digital control engineering analisys and desing m sam fadali

... digital control of a given analog control system. 3. Explain the structure and components of a typical digital control system. In most modern engineering systems, there is a need to control the ... digital controllers more economical even for small, low-cost applications. 1.2 THE STRUCTURE OF A DIGITAL CONTROL SYSTEM To control a physical system or process using a digital con...
Ngày tải lên : 01/01/2014, 20:22
  • 526
  • 464
  • 1
PRINCIPLES FOR THE RISK ANALYSIS OF FOODS DERIVED FROM MODERN BIOTECHNOLOGY

PRINCIPLES FOR THE RISK ANALYSIS OF FOODS DERIVED FROM MODERN BIOTECHNOLOGY

... future, foods derived from modern biotechnology will not be used as conventional counterparts. -2- SECTION 3 – PRINCIPLES 9. The risk analysis process for foods derived from modern biotechnology ... Foods Derived from Recombinant-DNA Animals (CAC/GL 68-2008). 7 See footnote 1. 8 Reference is made to the Compilation of Codex Texts Relevant to Labelling of Foods Derived fro...
Ngày tải lên : 13/03/2014, 21:56
  • 3
  • 576
  • 0
Terminology and symbols in control engineering

Terminology and symbols in control engineering

... diagram of a control loop controlling element measuring equipment controller final control element system actuator signal flow diagram of closed loop control elements and signals of a control loop Whenever ... control by means of fixed set point control w x follow-up controllers require good reference action fixed reference variable Cascade control Cascade control systems requ...
Ngày tải lên : 29/03/2014, 21:55
  • 28
  • 398
  • 0