separation of multiphase, multicomponent systems
... 727 23.3 Differential Separation of Multi-Componenet Mixtures 729 23.4 Separation of a Moving Layer 736 24 Separation with Due Regard of Hinderness of Floating Bubbles 743 24.1 Separation in the ... 713 22.5 The Effect of Surfactants on Bubble Growth 716 Contents IX 23 Separation of Liquid–Gas Mixtures 721 23.1 Differential Separation of a Binary Mixture 723 23.2 Contac...
Ngày tải lên: 02/04/2014, 16:34
... MSSV:08520582 -TRƯƠNG VĂN VĨ MSSV:08520470 Sau đây là bài dịch chương II trong sách “Principles of Digital Communication Systems and Computer Networks” của nhóm em. Phần I – Các hệ thống truyền thông số (Digital ... Shannon đặt nền móng về lý thuyết thông tin năm 1948. Cuốn sách của ông “A Maththemathical Theroy of Communication ” (Một lý thuyết toán học của sự truyền thông tin) được...
Ngày tải lên: 18/09/2012, 10:13
... the most used software for modeling and simulation of wind systems [1]. Wind turbine systems are an example of such dynamic systems, containing subsystems with different ranges of the time constants: ... size and state of battery charge (SOC), the terminal voltage or currents absorbed by consumers. One of the advantages of MATLAB software is that libraries offer a wide ra...
Ngày tải lên: 05/09/2013, 16:10
Simulation of Wireless Network Systems
... Throughput versus offered load for a 5 Mbps WLAN 13 Simulation of Wireless Network Systems This chapter deals with simulation of wireless network systems. We introduce the basics of discrete-event ... what level of detail. † Level of detail. This is determined based on the component’s effect on the stability of the Simulation of Wireless Network Systems 343 Figure 13.1 Over...
Ngày tải lên: 29/09/2013, 21:20
Motion Control Theory Needed in the Implementation of Practical Robotic Systems
... controlling input r = radius of the disk l = length to the center of mass of the pendulum m = mass of the pendulum g = acceleration due to gravity A simulation of the system was created using ... consideration in the design of vehicle power systems is the need for separate power busses for motor drive and control. Isolated systems of some type are required to keep m...
Ngày tải lên: 05/11/2013, 21:15
An Introduction to Intelligent and Autonomous Control-Chapter 5: Modeling and Design of Distributed Intelligence Systems
Ngày tải lên: 07/11/2013, 09:15
A review of agile manufacturing systems
... development of new systems (table 8). Manufacturing software systems play a key role in the implementation of process planning for agile manufacturing . However, current software systems are monolithic. ... overall development-time of the new product. The proposed method is based on the principles of group technology (GT), and on the de®nition of the neighbourhood of similar...
Ngày tải lên: 23/11/2013, 10:01
Performance Analysis of Network-MIMO Systems
... are often presented by “black boxes” 2.2.1 MIMO systems Model We consider a MIMO systems with a transmit array of M T antennas and a receive array of M R antennas. The block diagram of such ... MAC systems outperforms point-to-point MIMO systems especially when the number of receiver antennas at an AP is larger than the number of transmit antennas at each user. Fi...
Ngày tải lên: 26/11/2013, 20:49