MECHANICAL DESIGN AND CONTROL OF THE PENDUBOT potx
... drive control, we designed the Pendubot to hang off the side of a table coupling link one directly to the shaft of the motor. The mount and bearings of the motor are then the support for the entire ... first give details of the design of the Pendubot, discussing the components of the linkage and the interface to the PC used as the controller...
Ngày tải lên: 31/03/2014, 23:20
... changes to the RWC design and content that could improve the eectiveness of the RWC: • Clearly state the goals and core messages of the RWC on the website. • Review content and links on the website ... activities, and conferences and events. RAND’s Independent Assessment of the Real Warriors Campaign Methods To conduct the assessment of the design,...
Ngày tải lên: 30/03/2014, 05:20
Rheological heterogeneity, mechanical anisotropy and deformation of the continental lithosphere pdf
... orientation of the fast split shear wave polarization and the fast direction for Pn are also shown. The questions of the rooting of the fault into the asthenosphere and the interaction between the fault ... (dislocation glide and climb) on temper- ature. The geotherm controls the depth of the brittle– ductile transition, and the viscosity of both crus...
Ngày tải lên: 31/03/2014, 23:20
AUDIT OF THE CONTROL SYSTEM GOVERNING THE PRODUCTION, PROCESSING, DISTRIBUTION AND IMPORTS OF ORGANIC PRODUCTS potx
... attained recognition. These are the list of recognised control bodies/ authorities for the purpose of equivalence (not published at the time of the audit) and the list of recognised control bodies/authorities ... Audit of the control system governing the production, processing, distribution and imports of organic products THE AUDIT SCOPE 20. The audit...
Ngày tải lên: 28/03/2014, 19:20
practical guide to the packaging of electronics thermal and mechanical design and analysis
... as shock and vibration. Thermomechanical management is concerned with the impact of thermal loads on the mechanical behavior of the system. In this work, we will set the foundation ... on the left-hand side generates a heat load of 100. The surface temperature on the right- hand side is 75. What is the surface tem- perature on the left-hand...
Ngày tải lên: 03/06/2014, 01:25
The Design and Implementation of a Log-Structured File System
... sequen- tially, then writes 100 Mbytes randomly to the existing file, then reads 100 Mbytes randomly from the file, and finally reads the file sequentially again. The bandwidth of each of the five phases ... shows the relative importance of the various kinds of data written to disk, both in terms of how much of the live blocks they occupy on disk and in terms of h...
Ngày tải lên: 12/09/2012, 15:05
Design and Implementation of a Three-Phase Induction Motor Control Scheme
... calculate the speed and position of the rotor. The encoder pulses and the measured currents drawn by the induction motor form the feedback portion of the design. Hence, the major aim of this thesis ... develop a control strategy that varies the frequency and voltage of the signal applied to the windings of the induction motor, while controlling t...
Ngày tải lên: 27/10/2013, 23:15
Working with the Fogbow Design and reconfiguration of services and participation in e-Government
... adapt the tool and templates on the basis of the municipal present and forthcoming needs. One of the main tasks of the information department is the customization and implementation of the tool ... practices of design and use, and facilitate their coordination. We brought up the extension of design, and therefore participation, beyond the proje...
Ngày tải lên: 04/11/2013, 20:15