TOYOTA CELICA 4WD ST205 SERIES 1994 CHASSIS AND BODY HƯỚNG dẫn sửa CHỮA THÂN XE TOYOTA

Ngày tải lên: 28/03/2014, 10:16

... on body panel repair methods (including cutting and welding operations, but excluding painting) for the TOYOTA CAMRY. Applicable models: ACV 40 series GSV 40 series This manual consists of body ... when handling brake system parts. NOTICE: When repairing the brake master cylinder or TRAC system, bleed the air out of the TRAC sys- tem. 2. DRIVE TRAIN AND CHASSIS The drive train...

Ngày tải lên: 24/05/2014, 13:18

... (REMOVAL AND INSTALLATION) and includes illustrations to facilitate body repair. BODY PANEL REPLACEMENT RE-28 REMOVAL Cut and Join Location Cut and Join Location 150 mm 250 mm [Cut and Join Location] Cut ... body panel repair methods (including cutting and welding operations, but excluding painting) for the TOYOTA LAND CRUISER. UZJ100, FZJ10_ series HDJ10_, HZJ105 serie...

Ngày tải lên: 24/05/2014, 15:25

... the body and mounting bracket with the 4 bolts and 2 nuts. (b) Tighten the 3 bolts holding the mounting insulator to the body. Torque: 64 N·m (650 kgf·cm, 47 ft·lbf) (c) Tighten the 2 nuts and ... normal operating temperature. 2. CONNECT TOYOTA HAND−HELD TESTER OR OBD II SCAN TOOL (a) Remove the fuse cover on the instrument panel. (b) Connect the TOYOTA hand−held tester or OBD I...

Ngày tải lên: 24/05/2014, 16:26

Ngày tải lên: 28/03/2014, 09:22

... Remove the 3 bolts and air cleaner case. 19. REMOVE NO. 1 AIR CLEANER INLET (a) Remove the bolt and No. 1 air cleaner inlet. 20. REMOVE BATTERY (a) Loosen the bolt and nut, and remove the battery ... bolts and 2 clamps from the body. (c) Remove the bolt and clamp from the bracket. 35. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (a) Remove the clip and nut, and separate t...

Ngày tải lên: 23/05/2014, 16:53

Ngày tải lên: 23/05/2014, 16:02

... Date: 2004 LAND CRUISER (RM1071U) (c) Using a plastic-faced hammer and a brass bar, lightly tap out the piston pin and the pin and remove the connecting rod. HINT: L The piston and the pin are ... piston and connecting rod are different for the LH and RH banks. The LH piston is marked with ”LH” and ”2L”, the RH piston with ”RH” and ”2R”. (e) Align the piston pin holes of the...

Ngày tải lên: 24/05/2014, 15:30

Ngày tải lên: 28/03/2014, 09:19

... the needle, and control the start and stop of injection through moving the three-way valve up and down. Q001167E QR-Codes 30 Base 14 characters Solenoid Valve Control Chamber Command Piston Nozzle ... responsiveness and makes more precise control possible. The piezo element expands when voltage is applied. The piezo injector uses this characteristic to control the pressure of the cont...

Ngày tải lên: 28/03/2014, 09:21