should section 28 be repealed

Ngày tải lên: 21/02/2014, 20:20

... the point considered (FT) N 1 = number of intervals between the ground surface and a point 8D below the ground surface N 2 = number of intervals between 8D below the ground surface and the tip ... (1965) and should only be used for preliminary design. In Equations 1 and 2, the loading condition has been assumed to be axial load only, and the piles are assumed to be fixed at their ends...

Ngày tải lên: 06/09/2012, 15:57

Ngày tải lên: 04/10/2012, 10:24

... 122.343 đ 4.131 .284 đ Số chi phí dịch vụ mua ngoài trên đợc kế toán ghi vào sổ NKC, sau đó ghi vào sổ cái TK 331, TK 627 theo định khoản: 36 Nợ TK 617.7: 4.131 .284 Có TK 331: 4.131 .284 Đồng thời ... chức vụ Chức vụ Hệ số Mức lơng Hệ số Mức lơng Giám đốc XN xây lắp 3 ,28 47,3 0,30 43.200 Phó Giám đốc XN xây lắp 3,04 437,8 0,20 28. 800 Kế toán viên 2,98 390 Kỹ thuật viên 2,98 390 Thủ...

Ngày tải lên: 19/03/2013, 16:52

... number of physical education credits should be required for graduation from college. Use specific reasons and examples to support your response. I believe that physical courses should be required ... any physical activities. There are additional benefits of physical activity that I think are just important. In actual fact, physical activity can be of great value, especially to...

Ngày tải lên: 02/08/2013, 01:27

... private tuition after bearing their school tax burden. So, to my opinion, in the absence of a tax-supported system, parents will benefit by keeping their own money. The money belongs to the parents, ... to give their kids a ‘leg up”, the private-run schools are catching on due to their “better discipline” and “ better education”. Parents were also more satisfied with the ‘control of violence,...

Ngày tải lên: 16/09/2013, 23:10

... resistance of a belled shaft, the side resistance above the bell should conservatively be neglected if the resistance of the bell is considered, and it can be assumed that the bell behaves as an ... resistance of a belled drilled shaft in a cohesive soil, R R , in KIPS, should be determined as: bellsupnR RRR   (10.8.3.7.2-1) in which: ubellsbells AqR  (10.8.3.7.2-2) where: q sb...

Ngày tải lên: 29/09/2013, 12:20

... lateral spreading, piles bearing on suitable materials below susceptible soils should be considered for use as a protection against these problems. Piles should also be considered where right-of-way ... installation to establish when the bearing resistance has been met, a minimum pile penetration should not be used to insure that the required nominal pile bearing, i.e., compressio...

Ngày tải lên: 29/09/2013, 12:20

... bases should be avoided wherever possible. Where use of an inclined footing base cannot be avoided, the nominal bearing resistance determined in accordance with the provisions herein should be further ... correction factor should be used only when the soils above the footing bearing elevation are as competent as the soils beneath the footing level; otherwise, the depth correctio...

Ngày tải lên: 29/09/2013, 12:20

... (1999) 10-46 method for tip resistance in sand should be also be reduced. The amount of reduction should be based on engineering judgment. Shaft compression load test data should be extrapolated to production ... test specimen should be large enough to allow the full grain size range of the soil to be included in the specimen. This may not always be possible, and if not...

Ngày tải lên: 29/09/2013, 12:20