microtechnology and mems microtechnology and memsSeries Editor: H Fujita potx

... suspended. There are two kinds of surface micromachining: photolithography for a thick- ness less than several 10 µm, and electron beam lithography for a thickness of less than 1 µm. Photolithography Photolithography ... (Prob- lem 3.4). Both show the maximum when the focus is near the surface of the sphere and decrease as the focus comes to the center of the sphere. The po- sitions for t...

Ngày tải lên: 05/03/2014, 15:20

... predictable channel width and height. The channel width is determined by the feature sizes on the channel template used for imprint- ing. The channel height can be controlled by the depth of the template ... using the stamp shown in (b). The half pitch of the pattern is 50 nm and the area of patterns is 1 mm × 1 mm. (Reprinted with permission from S. Park, H. Schift, H. H. Solak, and...

Ngày tải lên: 13/02/2014, 08:20

... cube-shaped satellites launched in tethered pairs from a special PICOSAT launcher that is installed on the Space Shuttle, an expandable launch vehicle (ELV) or a host satellite. The launcher that will ... thereof. It is shown that the number of pure MEMS propulsion devices is limited, and that there are still significant challenges ahead for other technologies to make the leap. The major...

Ngày tải lên: 05/03/2014, 15:20

... proudly . l e ft and righ t and dar k and lig ht , and a ls o r o u g h and s m ooth . Of t en adding “dis” or “im” or sometimes even “non” w ill help you build an an t on ym wi th th ese beginnings ... lives in Toronto, Ontario, with his wife and two children. Antonym: A word that means the opposite of another word To my brother Kevin, who appreciates the richness of our...

Ngày tải lên: 30/08/2012, 10:50

... panel, sloped truss bridge. The bridge spans 60 feet, and has a width and height of 12 feet each. The supports are roll- ers at one end, and pins at the other. The trusses and cross members are to ... down the list until you find the last double angle, 2L4X4X7/16, and while holding down the shift key on the keyboard, click once on this section. All of the 2L4X4’s should now be h...

Ngày tải lên: 06/09/2012, 15:56

... associated with relying upon the command of law (which he terms ‘imperium’) with those associated with the government’s deployment of wealth (which he terms ‘dominium’): T. Daintith, ‘The techniques ... cyberspace through ordinary laws that apply to behaviour in the physical world (through the laws of copyright, defamation and so forth), although its effectiveness will vary depending upon t...

Ngày tải lên: 21/09/2012, 10:39

... a Length available for an activation mechanism h 0 ¼ R sin h Length available for the shoe structure h 1 ¼ rsin  acos  R r cos h  À h 0 Chapter 482 5 Dry and Wet Disk Brakes and Clutches This ... in an oil bath. Thus these brakes are isolated from dirt and water, and the circulation of the oil through a heat exchanger usually provides greater heat dissipation than can be...

Ngày tải lên: 20/10/2012, 09:58

... assays that detect and quantify HCV RNA and determine the HCV genotype. Anti-HCV antibody testing and HCV RNA testing are used to diagnose acute and chronic hepatitis C. Only patients with detectable ... 37 Chronic hepatitis C In patients with clinical or biological signs of chronic liver disease, chronic hepatitis C is certain when both anti- HCV antibodies and HCV RNA (sought...

Ngày tải lên: 02/11/2012, 09:56

... 2.0, the malformed packet must meet the following criteria: * The source IP is one of the targets * The destination IP is the other target * The source and destination port is 1745. * The data ... are the same as the ISA Server. * The source and destination port is 1745. * The data field is specially crafted and resembles the request format. An attacker with access to the LAN can anony...

Ngày tải lên: 02/11/2012, 14:19

Ngày tải lên: 07/02/2013, 09:32