Tài liệu NORSOK STANDARD MECHANICAL EQUIPMENT docx
... Rev. 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 Mechanical equipment R-001 Rev. 3, November 1997 NORSOK standard Page 8 of 33 5 TECHNICAL REQUIREMENTS 5.1 General 5.1.1 ... mm 36 Plate thickness mm 37 Genera...
Ngày tải lên: 22/02/2014, 09:20
... Lesson 6 Ship Equipment It is absolutely necessary for a ship to be equipped with varied ship equipment to satisfy the needs of voyage, harbour, operation and safety. Ship equipment varies ... vessels, and usually concerns the equipment for the rudder and anchor as well as for the life-saving, cargo-lifting and mooring. 1. The Rudder Equipment The rudder equipment is a plant...
Ngày tải lên: 25/01/2014, 23:20
... functionality Interchangeable Capable of exchanging places without alteration Standardized Meeting a standard, such as a performance or material standard or a shared process or resource Common Similarity across ... RAND mono- graphs undergo rigorous peer review to ensure high standards for research quality and objectivity. 2 Commonality in Military Equipment: Improving Acquisition Decis...
Ngày tải lên: 18/02/2014, 00:20
Tài liệu Cabling Standard - TIA - Cat 6 FAQ docx
... frequency that is supported by the test equipment, but such measurements are meaningless without the context of applications and cabling standards. The Category 6 standard sets minimum requirements ... scope of the Category 6 standard. The component requirements of the standard have been carefully designed and analyzed to assure channel compliance and electrical /mechanical interope...
Ngày tải lên: 10/12/2013, 02:15
Tài liệu Cabling Standard - TIA-EIA Structured Cabling Standards docx
... Telecommunication Cabling standard. Note that the ISO/IEC- 11801 Generic Customer Premises Cabling standard is an international cabling standard that is based on the ANSI/TIA/EIA-568 cabling standard. The ... Telecommunications Wiring Standard) This standard specifies residential cabling. • TI A/ EI A-606-1994 ( Building I nfrastructure Administration Standard) This standard d...
Ngày tải lên: 10/12/2013, 02:15
Tài liệu Measuring Your True Equipment Productivity docx
... calculate your current equipment productivity and determine your improvement potential. Equipment Productivity True equipment productivity is measured by Total Effective Equipment Productivity ... resources you invest in the program. =Equipment Utilization (EU) x Overall Equipment Effectiveness (OEE) OEE (Overall Equipment Effectiveness) =Equipment Availabi...
Ngày tải lên: 12/12/2013, 00:15
Tài liệu Handbook of Mechanical Engineering Calculations P7 docx
... Engineering. TABLE 6 Typical Spreadsheet for Ranking Equipment Criticality* Spreadsheet for calculating equipment PHCRS Equipment number Equipment description NFPA rating H F R RF PCH Other HCR ... Repetitive Equipment, CRE, value for this equipment This pump has an MTBF of 10 months. Therefore, from Table 4, CRE ϭ b1. Note that the CRE value will vary with the PCHR and MTBF values...
Ngày tải lên: 17/12/2013, 11:15
Tài liệu TIA Standard Catalog docx
... Safety Wideband Data Standards Project - Digital Radio Technical Standards $89.00 TSB-902.A 53 Digital Radio Technical Standards - Public Safety Wideband Data Standards Project - Wideband ... Routing Equipment Compatibility Standard This technical requirement form a compatibility standard for communication between a Personal Base (PB) and Authorization and Call Routing Equi...
Ngày tải lên: 20/12/2013, 22:15
Tài liệu Handbook of Mechanical Engineering Calculations P15 docx
... actual maximum rainfall, in (mm) /4. If the drain size obtained is nonstandard, as will often be the case, use the next larger standard drain size. Thus, with a 6-in (152-mm) rainfall and a 5-in ... room; and two drinking foun- tains in the public hall. 3. The basement is occupied for building equipment rooms, storage, utility, laundry, and general purposes and has the following provision...
Ngày tải lên: 25/12/2013, 23:18
Tài liệu Handbook of Mechanical Engineering Calculations P21 docx
... select standard inverted-tooth (silent) chain and high-velocity in- verted-tooth silent-chain drives, follow the same general procedures as given above, except for the following changes. Standard ... given chain pitch, number of chain strands, and various types of lubrication. Thus, Table 16 is for standard single- strand 5 ⁄ 8 -in (1.6-cm) pitch roller chain. The 9.79-hp (7.3-kW) ratin...
Ngày tải lên: 25/12/2013, 23:19