... facilities and, with them, promised to provide complete
and reliable access to all types of wireless services.
INDOOR WIRELESS COVERAGE
HISTORIC MOUNTAIN RESORT AND CONFERENCE CENTER
CASE STUDY
... spa.
Those mountains and the sprawling brick facilities made it nearly impossible for
guests to access wireless services. When new owners purchased The Homestead,
they set out to retain and...
... 1 - 7 CCNA 4: WAN Technologies v 3.0 - Lab 1.1.4c Copyright 2003, Cisco Systems, Inc.
Lab 1.1.4c Configuring Static NAT Addresses
Objective
• Configure ... WAN Technologies v 3.0 - Lab 1.1.4c Copyright 2003, Cisco Systems, Inc.
• 2500 series routers
• 2600 series routers
Please refer to the chart at the end of the lab to correctly identify ... identify the interface i...
...
This lab assumes the use of any version of Windows. This is a non-destructive lab and can be done
on any machine without concern of changing the system configuration.
Ideally, this lab is ... to the Internet.
This lab can be done from a single remote connection via a modem or DSL-type connection. The
student will need the IP addresses that were recorded in Lab 1. The instructor...
... of networking. This lab also helps increase the overall
understanding of some of the basic electrical circuit building blocks.
Prior to starting the lab, the teacher or lab assistant should ... 1 - 3 CCNA 1: Networking Basics v 3.0 - Lab 3.1.5 Copyright 2003, Cisco Systems, Inc.
Battery
Lab 3.1.5 Series Circuits
Switch
Bulb
Objective ... blocks.
Pr...
... the chart at the end of the lab to correctly
identify the interface identifiers to be used based on the equipment in the lab. The configuration
output used in this lab is produced from 1721 series ... Establishing a HyperTerminal session lab.
Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all
routers in this lab assignment before cont...
... the chart at the end of the lab to correctly identify the interface identifiers to be
used based on the equipment in the lab. The configuration output used in this lab is produced from
1721 ... Establishing a HyperTerminal session lab.
Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all
routers in this lab assignment before continuing....
... the chart at the end of the lab to correctly identify the interface identifiers to be
used based on the equipment in the lab. The configuration output used in this lab is produced from
1721 ... Establishing a HyperTerminal session lab.
Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all
routers in this lab assignment before continuing....