... Lab 3.2.3: Catalyst 2900 Setup
ALSwitch
2900XL
10.1.1.251/24
Console Cable
Workstation
10.1.1.10/24
Native
VLAN1
Objective:
Configure a Cisco Catalyst 2900 Ethernet switch ... no flow control.
2. Power on the 2900 switch and watch it start up. It will take a little over 1 minute for the 2900
to boot up.
C2900XL Boot Loader (C2900-HBOOT-M) Version 12.0(5)XU, RELE...
... Administration
Default Settings
4-16
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
CHAPTER
5-1
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software ... the
Catalyst 2900 XL and Catalyst 3500 XL switches, except for the access
class 199 that is created when a device is configured as the command switch.
5-3
Catalyst...
... as a backup link, when
the frame-relay connection to R5 is lost. Verify that you have basic
IP setup by pinging the local interfaces that you have just configured.
Points:
Configure OSPF ...
2
ASET Practice Lab
V4
R3
R4
R5
E0
2
4
Comm Serv
IP Address: 170.100.
Comm Server Setup
er
1.1
Diagram 2
3
R1(Frame)
R2
6
R6
Cat5 –
Con
diagram lan i
figure all...
... Lab 3.1.3.2: Catalyst 4000 Setup
DLSwitch1
4006
10.1.1.251/24
Console
Cable
Workstation
10.1.1.10/24
Native
VLAN1
Objective:
Configure a Cisco Catalyst 4000 Ethernet switch ... Catalyst 4000 Ethernet switch for the first time.
Scenario:
You have just purchased a new Catalyst 4000 Ethernet switch with a supervisor module and a 32
port layer 3 switch module. Configure...