Tài liệu Lab 3 2 5 Configuring Message of the Day pdf

... 1 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 3. 2. 5 Configuring Message of the Day Router Name FA0/0 Address ... 1 72. 16.0.1 1 72. 17.0.1 25 5 . 25 5. 0.0 RIP class cisco Objective • Demonstrate the commands to enter a message of the day (MOTD) on the router. This proce...

Ngày tải lên: 24/01/2014, 19:20

... 1 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 3. 2. 5 Configuring Message- of- the- Day (MOTD) Objective • Demonstrate the commands ... 1600, 1700, 25 00, 26 00 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used...

Ngày tải lên: 24/01/2014, 19:20

... 199.99.9 . 32 /27 have been allocated for Internet access outside of the company. Use the ip route command to create the static route: ISP(config)#ip route 1 72. 16. 12. 0 25 5 . 25 5 . 25 5. 0 1 72. 16.1.6 ... pool campus campus(dhcp-config)#network 1 72. 16. 12. 0 25 5 . 25 5 . 25 5. 0 campus(dhcp-config)#default-router 1 72. 16. 12. 1 campus(dhcp-config)#dns-serve...

Ngày tải lên: 11/12/2013, 13:15

... DCE 1 92. 168. 15. 1 25 5 . 25 5 . 25 5. 0 class cisco Router 2 BHM DTE 1 92. 168. 15 .2 255 . 25 5 . 25 5. 0 class cisco 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1 .5 Copyright  20 03, Cisco ... 1 92. 168. 15. 1 25 5 . 25 5 . 25 5. 0 GAD(config-if)#clock rate 56 000 GAD(config-if)#no shutdown GAD(config-if)#exit GAD(config)#exit...

Ngày tải lên: 11/12/2013, 13:15

... DCE 1 92. 168. 15. 1 25 5 . 25 5 . 25 5. 0 class cisco Router 2 BHM DTE 1 92. 168. 15 .2 255 . 25 5 . 25 5. 0 class cisco 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1 .5 Copyright  20 03, Cisco ... 1 92. 168. 15. 1 25 5 . 25 5 . 25 5. 0 GAD(config-if)#clock rate 56 000 GAD(config-if)#no shutdown GAD(config-if)#exit GAD(config)#exit...

Ngày tải lên: 18/01/2014, 04:20

... b. There is a third host needed for this lab. It needs to be configured with the address 1 92. 168.1.7. The subnet mask is 25 5 . 25 5 . 25 5. 0 and the default gateway is 1 92. 168.1.1. 2 - 7 CCNA 3: ... 1 - 7 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 6 .2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 6 .2. 5 Configuring Port Security O...

Ngày tải lên: 18/01/2014, 04:20

... with the address 1 92. 168.1.7. The subnet mask is 25 5 . 25 5 . 25 5. 0 and the default gateway is 1 92. 168.1.1. Note: Do not connect this PC to the switch yet. Step 3 Verify connectivity a. To verify ... to the Basic Switch Configuration lab. 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 6 .2. 5 Copyright  20 03, Cisco Systems, Inc. St...

Ngày tải lên: 18/01/2014, 04:20

... 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 3. 2. 1 Copyright  20 03, Cisco Systems, Inc. Lab 3. 2. 1 Configuring EIGRP Routing Objective ... configure the routing 2 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 3. 2. 1 Copyright  20 03, Cisco Systems, Inc. protocol until specifically told to. If there are an...

Ngày tải lên: 24/01/2014, 19:20

... to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1 721 ... at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3...

Ngày tải lên: 24/01/2014, 19:20

... fastethernet 0 GAD(config-if)#ip address 1 72. 16.0.1 25 5 . 25 5. 0.0 GAD(config-if)#no shutdown GAD(config-if)#exit GAD(config)#interface serial 0 GAD(config-if)#ip address 1 72. 17.0.1 25 5 . 25 5. 0.0 ... BHM(config-if)#ip address 1 72. 18.0.1 25 5 . 25 5. 0.0 BHM(config-if)#no shutdown BHM(config-if)#exit BHM(config)#interface serial 0 BHM(config-if)#ip address 1 72...

Ngày tải lên: 24/01/2014, 19:20