University of California College of Engineering Department of Electrical Engineering and Computer Sciences Problem Set Due Monday August 7th Octavian Florescu EE40 Summer 2006 Reading: Chap 12.1-12.6 Hambley Chap 3.3 of Rabaey Problems: Chap 12: 12.15, 12.24, 12.30, 12.37, 12.40, 12.47 (midband refers to the frequencies at which the capacitors are short), 12.51 Additional Problems: Problem VDD RD R1 VO VG R2 M1 RS The circuit above has the following parameters: VDD = 5V, R1 = 20kΩ, R2 = 30kΩ, RS = 1kΩ, RD = 9kΩ, VTh(M1) = 0.5V 1.2 ID (mA) 0.8 0.4 0.2 0 0.5 1.5 2.5 3.5 VGS (V) ID (mA) 0.5 0.4 0.3 0.2 0.1 0 0.5 1.5 2.5 VDS (V) a) Find the value of VG 3.5 4.5 b) From the ID vs VGS curve below, find the values of IDQ, VGSQ c) From the values of IDQ, VGSQ and VT, draw the ID vs VDS curve for M1 Assume λ = Annotate VGSQ, IDQ and the point where M1 enters saturation d) From the ID vs VDS curve you drew, find the value of VDSQ e) Is M1 in saturation? f) Find Vo Problem V DD RD Rs C1 = ∞ R1 + VG + vin R2 C gs CL = ∞ v out _- - Consider the Common Source amplifier above C gs is the capacitance between the gate and the source of the NMOS V DD=15 V V Tn=1 V μn C ox =100 μA V2 W =20 L λ =0 R1 =4 M R2=1 M R D=2K C gs=5 fF ( 1fF = 10−15 F) R L =20 K R s=10 K RL a What is I DSQ and V DSQ ? Hint: All the capacitors, including C gs , are open circuit for DC analysis b Draw the small signal model for the circuit and find the vg/vin Hint: All the capacitors except for C gs are short circuit for the small signal analysis Do include C gs in your small signal analysis c Find the small signal transfer function, v out v in Draw the bode plot for the transfer function Problem The circuit shown is biased so that both transistors are in saturation M1 is an N-MOS and M2 is a P-MOS The source terminals are indicated by the arrows a Draw the small-signal model of the P-MOS transistor in saturation (It should be very similar to an N-MOS, differing only by signs) Give expressions for gm2 and rd2 in terms of the MOSFET parameters and large-signal current b Draw the small-signal model of the whole circuit c Find the voltage gain of this circuit in terms of gm1, gm2, rd1, and rd2 Problem Find the transfer function of the following amplifier Use R1 = 10k, C1 = 0.01uF, R2 = 1k, C2 = 0.001uF, and Gm = 0.01S